695884
22
Zoom out
Zoom in
Previous page
1/88
Next page
ENGLISH
TECHNICAL DESCRIPTION
The appliance La Nordica is suitable to heat living spaces for some periods. As fuel, wood logs are used. The appliance works as an
intermittent operating appliance.
The appliance is made up of a steel chamber completely soldered and hermetic.
The hearth is totally sheathed with single cast-iron sheets and refractory plates (NORDIKER). Its back is extractable. Thanks to calibrated holes,
made on the same back, it is guaranteed a supply of pre-heated air inside the hearth, thus obtaining a post-combustion which increases the
eciency and reduces the emission of the unburnt gases. Inside it there is a turning and extractable grate. The inside smoke plate, reects the
re radiation and increases the internal temperature of the combustion chamber. This process together with the exhaust gases ows, makes
optimal the combustion and improves the eciency (see Picture 11).
The hearth is equipped with a panoramic door with ceramic glass (resistant up to 700 °C). This allows a wonderful view on the burning ames.
Furthermore, it is thus avoided the output of sparks and smoke.
Below the hearth door will be found an extractable ash-drawer with a closing door.
The heating of the environment is made by irradiation: through the panoramic glass and the external hot surfaces of the stove, the heat is
radiated into the environment (See chapter CALCULATION OF THE THERMAL POWER).
ACCESSORIES
POKER
GLOVE
Ventilation
KIT WIND AIR
Air channelling
FITTING (Picture 10)
SERIES SERIES OPTIONAL OPTIONAL
The openings for the combustion air (primary and secondary) are managed by one single register.
SINGLE register PRIMARY air and SECONDARY air (Picture 8).
The lever to adjust the combustion air is located underneath the re-door
With the air register located under the door of the hearth, it is possible to adjust the air ow through the ash drawer and the grating in
direction of the fuel.
The air is necessary for the combustion process during the ignition. The ash drawer has to be emptied regularly, so that ash cannot hinder
the intake of air for the combustion. The air is also necessary to keep re live.
With the lever totally PULLED OUT the SECONDARY airow is CLOSED and the PRIMARY airow is OPEN; with the lever totally IN the
PRIMARY airow is CLOSED and the SECONDARY airow is OPEN.
The adjustment of the registers necessary to reach the rated caloric yield is the following one:
Hourly wood consumption in kg/h Combustion air TERTIARY AIR
INSERTO 80 PRS WIDE
2,3 Picture 8 - B
PRE-ADJUSTED
INSERTO 80 WIDE
2,1 Picture 8 - B
PRE-ADJUSTED
INSERTO 100 WIDE
2,3 Picture 8 - B
PRE-ADJUSTED
It is possible to get the combustion air directly from outside through a exible tube reproof NOT furnished (see chapter VENTILATION
HOOD OR ADJACENT LOCAL).
FLUE
Essential requirements for a correct operation of the device:
the internal section must be preferably circular;
be thermally insulated and water-proof and produced with materials suitable to resist to heat, combustion products and
possible condensates;
not be throttled and show a vertical arrangement with deviations not greater than 45°;
if already used, it must be clean;
all the sections of the ue gas duct must be accessible to inspection;
inspection openings must be provided for cleaning.
observe the technical data of the instructions manual;
Should the ues have a square or rectangular section, internal edges must be rounded with a radius not lower than 20 mm. For the rectangular
section, the maximum ratio between the sides must be = 1.5.
A too small section causes a decrease of the draught. It is suggested a minimum height of 4 m.
The following features are FORBIDDEN and therefore they endanger the good operation of the device: asbestos cement, galvanized steel,
rough and porous internal surfaces. In Picture 3 gives some examples of execution.
For a correct installation please respect the sections/lengths of the ue shown in the technical data table. By installations
with dierent dimensions the ue must be suitably sized in accordance with EN13384-1.
22
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for La Nordica Inserto 80 PRS Wide at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of La Nordica Inserto 80 PRS Wide in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 7,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info