643400
31
Zoom out
Zoom in
Previous page
1/56
Next page
31
PRODUCT FUNCTIONING
Chapter 8
LIGHTING
Before proceeding, check to make sure that:1.
the hopper is loaded
the combustion chamber is clean
the burn pot is clean
the front door and the pellet drawer are closed
the power outlet is connected
the switch on the back of the stove is in position 1
Press button 1 for three seconds; display D1 will show the message 2. AT 08, with the numbers decreasing
every second. During this stage, the stove carries out an automatic check on the e ciency of each single
electrical component. When this cycle is completed, display D1 shows the message AC 15” (the number
of minutes for which the stove attempts the lighting stage, decreasing by 1 every minute that passes).
During the products’ first use, even if the tank is full of pellets, it is possible that for the first 15 minutes
the pellets are not distributed to the heating chamber, as the worm screw that loads the pellets is
empty.
If at the end of the 15 minutes the stove has not yet produced a flame, “NO ACC” will appear on the
display.
If steps 1 and 2 are carried out correctly, as soon as the  ame develops the stove enters the start-up 3.
phase (“AU 07”).
After the start-up phase, the stove goes into normal operation: display D1 shows the room temperature 4.
and D2 shows the heat setting.
WARNING!!!
NEVER USE FLAMMABLE LIQUIDS FOR LIGHTING1.
WHEN FILLING, DO NOT BRING THE SACK OF PELLETS INTO CONTACT WITH THE HOT 2.
STOVE
IN CASE OF CONTINUOUS UNSUCCESSFUL IGNITION, CONTACT AN AUTHORISED 3.
TECHNICIAN
NORMAL OPERATION
Once the stove is lit, you can adjust the heat setting using buttons 4 and 5. Pressing button 4 decreases
the heat setting and hourly pellet consumption; pressing 5 increases them. In addition to the feed rate,
the room temperature can be set directly from the control panel. The stove adjusts itself automatically in
relation to the warm air ventilation.
The functioning of the Divina Plus model is similar to that of the other models, with the addition of a 2nd
motor for the channelling. During the stoves normal functioning, the second fan will follow the course of
the first fan. It will be possible to enable/disable the functioning of the 2nd motor and gradually increase/
decrease the ventilation of the same as a percentage.
The contents of the hopper should be monitored to prevent the stove going out due to a lack of fuel.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for La Nordica Babyfiamma at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of La Nordica Babyfiamma in the language / languages: English as an attachment in your email.

The manual is 2,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of La Nordica Babyfiamma

La Nordica Babyfiamma User Manual - German - 56 pages

La Nordica Babyfiamma User Manual - French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info