17490
143
Zoom out
Zoom in
Previous page
1/167
Next page
Section 10 TROUBLESHOOTING
2A080030A
KM-6230 (KME)
/ 131
Action Page
“PUNCH HOLE CONTAINER FULL.”
The hole-punch waste tank in the optional Finisher is full. Dispose of the punch
waste.
3-3
“STAPLER EMPTY. ADD STAPLES.”
The optional Finisher has run out of staples. Replace the staple cartridge.
“PAPER DRAWER IS OUT OF ORDER.
SELECT OTHER PAPER DRAWER.”
The drawer currently in use is out of order and cannot be used at the moment.
“CANNOT BE COMBINED.”
The functions that you selected on the touch panel cannot be combined. Select
other functions.
“COPY LIMIT FOR THIS ID-CODE IS
REACHED. NO COPYING POSSIBLE.”
The number of copies that was allotted for that department code under the copy
“DUPLEX UNIT IS OUT OF ORDER.
1-SIDED COPYING IS POSSIBLE.”
There is a problem in the duplex unit. Two-sided copying is not possible. Contact
the service representative for your copier as soon as possible.
8-1
“PAPER CAPACITY EXCEEDED. REMOVE
PAPER FROM FINISHER.”
The number of sheets in the optional Finisher exceeds the acceptable capacity.
Remove all finished copies and press the Start key.
8-27
Message
“RESET ALL ORIGINALS IN FEEDER
AND PRESS START KEY.”
The first original was not fed correctly into the DF. Remove all originals and then
set them in the DF once again.
10-2
“MEMORY FULL.”
The corresponding box has reached its acceptable limit of data under the copy
management function. In order to register new data into one of the boxes, it is
8-23
SYSTEM ERROR. MAIN SWITCH OFF/ON.
“PLEASE WAIT. NOW MAINTAINING
STORED DATA.”
“FELT CLEANING MAINTENANCE.”
An error has occurred during data management. Turn the main switch OFF (O)
and then back ON ( | ) again, then attempt the procedure again from the
beginning.
The hard disk is now being optimized. Please wait until optimization is complete.
It is time to replace certain parts in the copier. Contact the service representative
for your copier as soon as possible.
“CHANGE FELT CLEAN. -(F.UNIT) CANNNOT
COPY.”
It is time to replace certain parts in the copier. Contact the service representative
“SCANNER IS OUT OF ORDER.
CALL FOR SERVICE.”
“TOO MUCH PAPER IN DRAWER.
REMOVE PAPER ABOVE RED LINE.”
There is a problem with the scanning function of the optional Print/Scan System.
Contact the service representative for your copier as soon as possible.
The amount of paper loaded in the optional Side Deck exceeds the acceptable
capacity of that deck. Remove some of the paper from the Side Deck.
9-6
9-9
143


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kyocera KM6230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kyocera KM6230 in the language / languages: English as an attachment in your email.

The manual is 6,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info