17480

Kyocera KM5530 Manual

26
Zoom out
Zoom in
Previous page
1/250
Next page
Section 3 PREPARATIONS
3-6
(1) Setting originals in the Document Processor
The Document Processor automatically feeds and scans each
original, one by one, for copying. You can also have two-sided
originals turned over automatically in order to make two-sided copies
or separate copies from each side.
1 Cautions when using the Document Processor
DO NOT set originals of the follow types in the Document Processor.
In addition, when using perforated sheets or originals with punch
holes, DO NOT insert the end with the perforations or holes first.
• OHP film and other transparencies
• Carbon paper, crumpled originals or originals with strong folds, and
soft originals such as vinyl
•Originals which are not rectangular, wet originals, and originals with
adhesive tape or glue
• Originals with clips or staples (In order to use such originals, remove
the clips or staples and straighten any crumples or folds before
using them. Failure to do so may cause originals to misfeed.)
• Clippings or originals with very slippery surfaces
• Originals with wet correction fluid
• Originals with folds (If you must use such originals, smooth out the
folded portions before setting them in the Document Processor.
Failure to do so may cause originals to misfeed.)
2 Originals that can be set in the Document Processor
• Sheet originals
• Paper weight:
One-sided originals: between 35 g/m
2
- 160 g/m
2
Two-sided originals: between 50 g/m
2
- 120 g/m
2
• Size: Max. 11" x 17" or A3 - Min. 5 1/2" x 8 1/2" or A5R
• Number of sheets:
100 sheets (under 11" x 8 1/2" or A4 size [75 g/m
2
or 80 g/m
2
])
70 sheets (over 8 1/2" x 14" or B4 size [75 g/m
2
or 80 g/m
2
])
30 sheets (when using the auto selection mode)
3 How to set originals in the Document Processor
1
Adjust the original insert guides to fit the size of the originals.
NOTE
Before setting any new originals, remove any originals that are
remaining on the original ejection table. If ejected originals are left on
the original eject table, they may cause other originals to misfeed.
2
Arrange the originals in order and set them face up (first
page face up for two-sided originals) onto the original table.
Slide the leading edge of the originals all the way into the
Document Processor, as far as they will go.
* When setting large size originals such as 8 1/2" x 14",
11" x 17", B4 or A3, be sure to open the ejection extension.
2. Setting originals
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kyocera KM5530 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kyocera KM5530 in the language / languages: English as an attachment in your email.

The manual is 8,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info