17456
91
Zoom out
Zoom in
Previous page
1/124
Next page
7-1
Section 7 OPTIONAL EQUIPMENT
Document Processor
The Document Processor automatically feeds one-sided originals
one by one for scanning. If also reverses two-sided originals
automatically for duplex copying and page separation copying.
Originals that can be used with the Document
Processor
Sheet originals only.
Single-sided originals that have a paper weight within the range
of 45 g/m
2
to 160 g/m
2
.
Two-sided originals that have a paper weight within the range of
50 g/m
2
to 120 g/m
2
.
Sizes: 11" × 17" to 5
1/2" × 8 1/2", Oficio II, A3 to A5R, Folio
No. of Sheets that can be loaded:
50 sheets (50 - 80 g/m
2
)
(Note, however, that when in Mixed Size Mode, this number is
reduced to 30 sheets.)
Notes on acceptable documents
Be sure NOT to use the following as originals in the Document
Processor. In addition, originals with punched holes or perforations
should be set so that the edge of the paper with the holes or
perforations is facing away from the direction of insertion into the
Document Processor.
OHP film or other transparencies.
Soft originals such as carbon or vinyl paper, or other originals
that are curled, wrinkled or creased.
Irregularly shaped originals, wet originals, or originals that have
adhesive tape or glue on them.
Originals bound with clips or staples. (If you must use such
originals, be sure to remove the clips or staples, and straighten
any curls, wrinkles or creases, before setting them in the
Document Processor. Failure to do so may result in the originals
being misfed.)
Originals with cut-out sections or that have a slippery surface on
either side.
Originals on which any correction fluid is still wet.
Originals with strong folds. (If you must use such originals, be
sure to smooth out the folds before setting them in the Document
Processor. Failure to do so may result in the originals being
misfed.)
Originals with sharp curves (when use of a curved original is
unavoidable, straighten out the curves before setting it).
Section Names
(1) Original Table
Set the original here.
(2) Original Insert Guides
Adjust these to match the size of the original.
(3) Left Cover
Open this when the original is jammed.
(4) Original Eject Table
Originals that have been copied are stored here.
(5) Ejection Extension
Open this when A3 or B4 originals are to be copied.
(6) Document Processor Open/Close Handle
Grasp this handle to Open/Close the Document Processor.
(7) Ejection Tray
The original will be temporarily ejected when copies of both
sides are made.
(2)(1)(2)(3)
(6)
(5)(4)
(7)
91


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kyocera KM2020 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kyocera KM2020 in the language / languages: English as an attachment in your email.

The manual is 10,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info