17442
68
Zoom out
Zoom in
Previous page
1/92
Next page
Section 8 TROUBLESHOOTING
8-2
“E72” appears on the copy quantity/
magnification display
Originals for another job were set in the optional Document Processor
during copying from the platen in the 2-in-1 or 4-in-1 layout mode. or in
the Sort mode.
Remove the new originals from the Document Processor and, once the
copy operation for the 2-in-1 or 4-in-1 layout mode or the Sort mode is
completed, reset them on the original table and try to copy again.
“E90” appears on the copy quantity/
magnification display
The copier’s memory is full.
To copy from those originals already scanned:
Press the Recall%/Enter key and copying will begin. Once those copies
have been made, reset the originals that have not yet been copied and
press the Start key. Copying will continue.
To start the copy procedure once again from the beginning:
Press the Stop/Clear key, set a lesser number of originals and try to copy
again.
“OP” appears on the copy quantity/
magnification display
The upper front cover or the front cover to the copier is open.
Close the covers securely.
“OP1” appears on the copy quantity/
magnification display
The left cover to the Document Processor is open.
Close the cover securely.
“J” and a number appear on the copy
quantity/magnification display
A paper jam has occurred.
Refer to “If paper jams” on page 8-3 and remove the jammed paper.
8-3
The Add Toner indicator lights The toner supply has run low.
Copying will still be available for awhile, but will then become impossible.
Replace the toner container as soon as possible.
9-2
The Add Toner indicator lights and “E33”
appears on the copy quantity/magnification
display
Toner has run out so further copying is impossible.
Replace the toner container.
9-2
“C” and a number appear on the copy
quantity/magnification display
Turn the power switch OFF ({) and then back ON ( | ) again. If the error
indication does not go out, make a note of the “C” and the number. Turn
the power switch OFF ({), remove the power cord, and contact your
service representative or an authorized service center.
“A” and a number appear on the copy
quantity/magnification display
Turn the power switch OFF ({) and then back ON ( | ) again. If the error
indication does not go out, make a note of the “A” and the number. Turn
the power switch OFF ({), remove the power cord, and contact your
service representative or an authorized service center.
Indication Procedure
Reference
Page
68


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kyocera KM1500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kyocera KM1500 in the language / languages: English as an attachment in your email.

The manual is 5,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info