20371
38
Zoom out
Zoom in
Previous page
1/131
Next page
25
Setup
Connecting the Serial Interface
To connect the printer to a computer using the serial interface, use the XSER connector
at the rear panel of the printer. The serial connector is of a round, 8-pin DIN type and
you will need a cable adaptor (SA-80) if you connect a DSub type serial connector.
Barcode Reader (BC-1)
With the harddisk option (see below) installed, you can take the advantage of the Kyocera
MPS (Multiple Print System). The barcode reader then allows you to recursively print the
jobs cached in the harddisk by reading the barcode printed on the printed job. For more
information, refer to the user’s manual supplied with the barcode reader.
Installing the Harddisk Option
The printer can be optionally installed with a harddisk kit HD-2C. Once the harddisk is
installed, the printer can temporarily or permanently cache the print jobs in the harddisk
so that you can print multiple collated copies quickly or take the advantage of the
barcode reader system. (See the preceding section.) The printer must be equipped with at
least 12MB of RAM in order to install the harddisk option.
Installing the harddisk option requires removal of the main controller board and
mounting the harddisk on it and therefore requires a qualified technician. See your
dealer from which the printer is purchased for installing the harddisk.
Power On
1
Turn ON the printer, then the computer. The printers power switch
is located at the bottom right side of the printer.
2
(1) All the indicators on the printer lights briefly and Self test is
displayed on the printer message display.
(2) After approximately 5 minutes, the ON LINE indicator is
illuminated and Ready is displayed on the printer message
display.
The printer is ready for printing.
Note:
When you power on your system for the first time, if “New Hardware Found” is
displayed on the computer screen, refer to page 29.
Back side
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kyocera FS5800C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kyocera FS5800C in the language / languages: English as an attachment in your email.

The manual is 2,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info