20353
113
Zoom out
Zoom in
Previous page
1/124
Next page
C.2. RS-232C/RS-422A Interface
C-6
3. Pull the main circuit board all the way out of the
printer.
Before pulling the main board out, clean an
area on the table, etc., at the back of the
printer's rear panel. Foreign objects, acciden-
tally sticking to the back of the main board,
can cause serious damage to the printer.
Changing the Jumper Connector
1. Carefully remove the jumper connector from the
main circuit board, and reconnect to the pin
position shown in the diagram.
2. After completion of the above, return the main circuit board to the printer by reversing the procedure
followed when removing it.
Verifying the Setting
The procedure described below should be followed to verify that the RS-422A mode had been correctly set.
Print the service status page to verify that the RS-422A mode has been correctly set.
1. Make sure the power switch is off. Plug the power cord into the printer and turn power on.
2. If the printer is on-line, selectý! !3ULQW 6WDWXV SDJH in the Mode Select menu (refer to Mode
Select Menu at the end of this document), and print the service status page.
3. Verify whether the setting is correct by checking the status printed at the bottom of the page. The fol-
lowing sample indicates that "RS-422A" is set "RS4". If "RS-232C" is set, "RS2" appears.
Jumper Connector
Jumper Connector
[Printer Status Page]
Indicates the current serial
interface mode.
113


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kyocera FS3750 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kyocera FS3750 in the language / languages: English as an attachment in your email.

The manual is 4,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info