20349
35
Zoom out
Zoom in
Previous page
1/154
Next page
1.4. Setting Up and Interfacing
1-14
10—Print a Status Page
Test that the printer works by printing out a status page as follows.
1.
Switch on the printer's power. The message display should indicate .
When the printer is first switched on after installation, there will be a delay of sev-
eral minutes (approx. 6 to 7 minutes) before the printer gets ready to print. During
this period, the message display shows .
2.
Wait until the ON LINE indicator is also lit and the message display indicates .
3.
Press the STATUS key. The printer should print a page listing the positions of margins, memory
allocation, and other information.
A sample status printout is shown in Chapter 2.
11—Test the Interface with the Computer
Test that the printer and computer are correctly connected. If you have connected the printer and
computer with a parallel interface cable, follow the procedure below.
1.
Check that the printer's message display indicates  and that the ON LINE indicator is
ON.
2.
Boot the computer in DOS mode, or set the computer to DOS (prompt) MODE.
3.
At the DOS prompt, type the following.
ECHO !R! STAT; EXIT;>PRN
If the printer prints a status page, the computer and printer are connected correctly. For details on
the status page, refer to Chapter 2.
If you do not get this result, check that the cable is securely plugged in at both ends, and repeat
the test. If you still do not get the right result, you may have a defective or improperly-wired cable.
Try using a different cable.
12—Set the Emulation Mode
The printer emulates the operation of five other printers. It is factory-set to emulate the HP LaserJet
5M at power-up. If you primarily use software that supports HP LaserJet 5M, or that supports the
Kyocera printer itself, the factory setting is the one you want. If you primarily use software that
supports another printer, it is convenient to change the printer's power-up emulation mode.
The emulation mode can be changed from the printer control panel. To change the emulation
mode, refer to the Mode Select Menu diagram on the last page of this manual.
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kyocera FS3700+ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kyocera FS3700+ in the language / languages: English as an attachment in your email.

The manual is 5,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info