598321

Kymco People S 200 Manual

23
Zoom out
Zoom in
Previous page
1/72
Next page
21
Break-in recommendations
The first 600 miles (1,000 km) of riding are the most important
in the life of your scooter. Following proper break-in proce-
dures during this time will help ensure maximum life and per-
formance from your new scooter. Proper break-in operation
allows the machined surfaces to polish each other and mate
smoothly.
Your scooter’s reliability and performance depend on your
exercise of special care and restraint during the break-in pe-
riod. It is especially important that you avoid operating the
engine in a manner which could expose the engine parts to
excessive heat.
The following guidelines should be followed during the break-
in period:
Maximum throttle operation:
Initial 300 miles (600 km): ........ Less than 1/2 throttle
Up to 600 miles (1,000 km): ..... Less than 3/4 throttle
Vary the engine speed:
The engine speed should be varied and not held at a constant
rate for long periods of time. This allows the parts to be "loaded"
with pressure, and then unloaded, allowing the parts to cool.
This aids in the mating process of the engine and transmis-
sion components. It is essential that some stress be placed
on these components during break-in to ensure that this mat-
ing process occurs. Do not, however, apply excessive load on
the scooter's drive line.
Avoid constant low speed:
Operating the engine at constant low speed (light load) can
cause parts to glaze and not seat in properly. Allow the engine
to accelerate freely through the gears, without exceeding the
recommended throttle openings.
Avoid using full throttle for the first 300 miles (600 km).
The initial service:
The 200 mile (300 km) initial service is the most important
service your scooter will receive. Take extra care to observe
your scooter’s initial service in a timely fashion. During
the break-in period, all of the engine components will have
worn in, and all of the other parts will have seated in, so ad-
justments will be required. All fasteners will be tightened, and
the contaminated engine oil will be replaced.
NOTE: Completion of the 200 mile (300 km) initial service
will ensure optimum service life and performance from
your scooter. Do not delay in having this service performed
once your scooter reaches this mileage.
SECTION 3 -
OPERATION
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kymco People S 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kymco People S 200 in the language / languages: English as an attachment in your email.

The manual is 4,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info