522406
12
Zoom out
Zoom in
Previous page
1/29
Next page
12
Follow these steps to connect power to the MCU.
The MCU supplies power to the antenna.
a. Before you begin, disconnect vessel power.
b. Connect a power cable to 24 VDC (2.5 amps
continuous) vessel power (for power cable
specifications, see Figure 3 on page 3).
Power
supplied to the antenna MUST NOT fall
below 18 VDC or exceed 30 VDC.
NOTE: If a 24 VDC power supply is not available,
install an AC/DC converter that supplies 24 VDC
(KVH part #19-0488 or equivalent).
c. KVH recommends you install a 15-amp
circuit breaker between power and the MCU.
The MCU does not have an on/off switch.
d. Install the ferrite coil, supplied in the kitpack,
onto your vessel power cable (close to the
MCU) to help reduce conducted emissions.
Make two loops in the cable and clamp the
coil around the loops (see Figure 21). This
ferrite coil must be installed to comply with
the CE standard.
e. Find the plastic power plug supplied in the
kitpack (see Figure 22). Insert your vessel
power wires into the plug’s power (+) and
ground (-) terminals. Tighten the plug’s
terminal screws to secure the wires in place.
f. Plug the plastic power plug into the “Power
In” jack on the MCU (see Figure 23). Secure in
place with the two retaining screws.
CAUTION
For your own safety, disconnect vessel power
and make sure the circuit is dead before you
connect any power wires.
Connect Power
Figure 21 Ferrite Coil Clamped onto Power Cable
Figure 22 Power Plug
Figure 23 MCU Power Connection
Ferrite Coil
Terminal
Screw (x2)
Retaining
Screw (x2)
Positive Ground
Power In
9
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KVH TracVision M9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KVH TracVision M9 in the language / languages: English as an attachment in your email.

The manual is 7,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of KVH TracVision M9

KVH TracVision M9 User Manual - English - 73 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info