522402
8
Zoom out
Zoom in
Previous page
1/17
Next page
8
Follow these steps to mount the antenna to the
mounting surface.
a. Align the four holes in the antenna’s
baseplate with the four holes in the mounting
surface. Ensure the “Forward” arrow inside
the baseplate points toward the bow and is
parallel to the vessel’s centerline (see
Figure 14).
b. Secure the antenna’s baseplate to the
mounting surface using four 1/4"-20 bolts,
5/8" washers, 1" washers, and lock nuts, as
shown in Figure 15 and Figure 16.
c. Tighten the bolts until the foam seal is
compressed and the antenna’s four rubber
feet are bottomed against the mounting
surface.
d. Reinstall the antenna’s radome to protect the
antenna while you’re working belowdecks.
While pressing the radome down onto the
base, secure the radome to the base using the
three #10-32 screws you removed earlier.
Later, you will remove the radome again to
set the LNB skew angle.
Figure 14: “Forward” Arrow
Be sure to insert the mounting bolts from
above and use the supplied hardware for a
secure installation.
IMPORTANT!
Figure 15: Tightening the Mounting Bolts from Above
1/4"-20 x 3" Bolt
1/4" Flat Washer
(5/8" diameter)
Antenna Base
Foam Seal
Mounting Surface
1/4" Flat Washer
(1" diameter)
1/4"-20 Lock Nut
Figure 16: Mounting Hardware
Mount the Antenna
6
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KVH TracVision M3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KVH TracVision M3 in the language / languages: English as an attachment in your email.

The manual is 2,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of KVH TracVision M3

KVH TracVision M3 User Manual - English - 65 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info