653337
9
Zoom out
Zoom in
Previous page
1/10
Next page
Motor is stuck or has
stopped
Juice yield is low
Juicing bowl shakes in the
middle of operation
Seems like juicing screw is
grinding
Juicer is noisy
Check that the cord is plugged in properly
Check all parts are assembled correctly.
The juicer may stop if the ingredients are fed into the hopper too quickly.
Turn the switch to
OFF
position and press down
REVERSE
switch to push up the
ingredients. Press the
FORWARD
switch to pull the ingredients down. (repeat
if needed)
Turn the switch to
OFF
position and unplug the power cord from the wall outlet.
Let the juicer rest to cool o from overheating.
When using the ingredients with hard seeds, pit before extraction. Seeds may
damage the strainer if not pitted from the ingredients.
Every ingredient yields di erent amounts of juice.
Soak the ingredients in water before extracting if the ingredients are dry or
not fresh.
When extracting ingredients like carrots or beets, extract with a combination of
other fruits and vegetables with more water content to increase the juice yield.
Cut ingredients to 4-5 inches long and 1 in wide for optimal extraction.
Check that the compression silicone is assembled properly in the unit.
When extracting seeded fruits like tomatoes, the strainer may get clogged with
the excessive amount of small seeds. Pour water through the hopper to unclog
before continuing extraction.
It is normal for the juicing bowl to shake a little bit during operation.
The juicing screw and the strainer are closely aligned with small tolerances.
Do not operate without inputting any ingredients for more than 30 seconds.
The rotation wiper may make a squeaking noise while wiping the juicing bowl.
After inserting ingredients the noise should disappear.
Turn the switch to
OFF
position and unplug the power cord from the wall outlet.
Check the parts are assembled properly.
Check that the juicer is on a level surface.
Check that the ingredients are cut to appropriate size.
*The warranty and product liability do not cover problems related to commercial or improper use of the product.
Problem Possible Reasons & Solution
I see a separation in the
juice extracted
The juice leaks out of the
top set
I see discoloration of the
plastic parts
There may be a separation in the juice due to the ingredients' density after
extraction. This is di erent from oxidation that is caused by juicing with
a traditional high speed juicer.
The juice may leak if the compression silicone is not assembled properly.
Disassemble and ensure the compression silicone is assembled properly. (pg 15)
After use, clean the juicer immediately to prevent discoloration.
Beta carotene (found in carrots and spinach) pigment may discolor the plastic
parts of the juicer. Rub the parts with a little bit of cooking oil then clean with
a mild soup.
The silicone parts can be removed and cleaned separately.
Problem Possible Reasons & Solution
‘LIFE TASTES GOOD
GLOBAL COMPANY
Troubleshooting
17
16
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kuvings NS series - UL-100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kuvings NS series - UL-100 in the language / languages: English as an attachment in your email.

The manual is 1,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info