513471
14
Zoom out
Zoom in
Previous page
1/14
Next page
EEB 9550.0 31
Rating label
The rating label for the oven is located
on the right-hand side strip and is visible
when the oven door is open.
Always indicate the data provided on the
rating label when calling in Customer
Service or ordering spare parts.
Make a note of this information in case you have to consult our customer
service.
Installation instructions for fitter
Only KÜPPERSBUSCH built-in hobs were designed and tested for use above
a Küpperbusch fitted oven. No other hobs may be used.
Statutory regulations and the connection specifications issued by the local
power supply company must be strictly observed.
When carrying out repairs the unit must be disconnected from the mains.
Disconnect the appliance from the mains, disconnect fuse.
It must not be possible to touch components which are insulated under ope-
rating conditions.
The unit is ready to plug in and may be connected only to a properly installed
protected socket. Installing and wiring a socket or replacing the connection
cable should only be performed by an electrician and in observance of the
relevant regulations.
If the socket is inaccessible after the installation, safety regulations require that
an all-polo isolator with a contact opening of at least 3 mm be used on the in-
stallation side.
The socket for plugging in the unit must be outside the installation space.
If you install the oven flush-left into the corner of an L-shaped divided kitchen,
you must maintain a distance of at least 15 cm to the left or the corner!
Built-in kitchen fixtures must be temperature resistant up to 100°C. This ap-
plies especially to veneers, plastic coatings, adhesives and varnishes. Adja-
cent cabinetry front must be temperature resistant to at least 70°C.
The unit must be installed absolutely horizontal on a level, solid base. The
base must not be allowed to sag.
If the cupboard element is not attached to the way, screw on using an or-
dinary bracket.
Installation dimensions
Electrics
[
WARNING! This appliance must be earthed!
Electrical requirements (for UK and Republic of Ireland only)
Check that the voltage stamped on the rating plate corresponds with your
house electricity supply, which must be AC (alternating current).
Electrical connection of the apppliance must be performed by a trained elec-
trician. The legally recognized regulations and the connection requirements of
the electricity board seving your area must be fully complied with.
[
WARNING! Should the oven be supplied with a continental two-pin plug
fitted, then this plug must be cut off from the connection cable. Dispose
of the plug safely; do not insert it in a 13 A socket elsewhere in the house
as this could cause a shock hazard.
Connection for UK and Republic of Ireland only: Permanent connection
to an oven power point (fuse: 20 A!).
Other countries:
Connection is via the mains plug into a wall socket.
Total rating at 230 V: 3.5 kW,
at 235 V: 3.6 kW
Electrical connection 230 - 240 V, 50 Hz
Fuse current 16 A
Installation in a fitted kitchen
The included clips are installed on both sides of the unit; these clips snap into
mounted support brackets in the cupboard element. The support brackets are
supplied with the unit. They must be mounted before installing the unit on
both cabinet inner sides as shown in the following illustrations:
Place the support bracket 280 mm
from the bottom edge of the cabinet
with the raised parts towards the ca-
binet, mark and drill the rear
holes (1).
Slide support bracket so that the front
holes lie over the drilled holes.
Use screws supplied to fasten the
support bracket to the cabinet.
Screw clips to the side walls.
Insert power plug and
slide unit into cabinet ope-
ning into it snaps into pla-
ce. Be careful not to pinch
the power cable! The ca-
ble is not permitted to
come into contact with the
back or floor of the unit
once it is installed.
Production-no.
Model designation oven
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kuppersbusch EEB 9550.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kuppersbusch EEB 9550.0 in the language / languages: English as an attachment in your email.

The manual is 0,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kuppersbusch EEB 9550.0

Kuppersbusch EEB 9550.0 User Manual - German - 17 pages

Kuppersbusch EEB 9550.0 User Manual - Dutch - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info