This accessory comprises four terminals (WAGO 221-415 / 5 poles) (6).There is a terminal for each wire color of the control line.
The control cables can be connected to the terminals stripped in accordance with the diagram or using the standard wire end ferrule. Please ensure that the cables are only connected
to cables of the same colour.
First open the clamping levers on the terminals (7). Now feed the control cables with the wire end ferrules or stripped for at least 11 mm into the terminals. Finally close the clamping
levers (8) and check whether the cable is correctly in place.
2.9Accessories
2.9.1Switching unit
In the event of an alarm, the switching unitcan actuate power consumption devices such as a fan, additional visual and audible warning signals with a maximum
load of 16 A.
The switching unit is connected by means of a distributor to the warning unit (see 2.2).
The switching unit itself can be plugged into a 230 V / 50 Hz power socket.
On the rear of the unit, you will find a switch inserted into the housing. This allows the relay to be selected in the event of a main or pre-alarm.
2.9.2Signal unit
The signal unit is installed in the same way as the warning unit (2.4).
Like all of the other system components, the signal unit is connected by means of the distributor to the warning unit. The control lines are connected to the
distributor in a colour-identical manner as shown in 2.5.
A plug and/or permanent connection is necessary for independent power supply.
When initialising the entire system (on the warning unit only!), you must ensure that the
mains power is provided to the signal unit; i.e. the signal unit must be running during
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Kundo xT CO2 Control at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Kundo xT CO2 Control in the language / languages: English as an attachment in your email.
The manual is 1,55 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
