735582
6
Zoom out
Zoom in
Previous page
1/8
Next page
Assembly instrucons CO2 CONTROL AM / AM PLUS
-6-
Assembly 7
14. Once the AM / AM PLUS unit is completely wired, the unit should
be closed up again. To do this, ghten the mounng screws ④ on the
housing. When closing up the device, note that for AM PLUS units,
you will rst of all need to reconnect the alarm light to the circuit
board, in socket ⑩ (see Image 13 on Page 5).
When screwing on the cover, make sure that
this is ght, so as to ensure the connued seal
of the device. KUNDOxT accepts no liability
for damage due to incorrect installaon!
15. Seng the geographic height
On the le side of the warning unit, there is
a rotary switch for seng the locaon
height at which the detecon system is
installed.
Check the current height against the height
range given in the table and set the posion
(0...9) of the switch so that the number on
the switch is above the marking on the
housing (for more details, see Item 16 on
Page 6).
Level
Height [m]
above sea level
0 0 .. 250
1 250 .. 500
2 500 .. 750
3 750 .. 1000
4 1000 .. 1250
5 1250 .. 1500
6 1500 .. 1750
7 1750 .. 2000
8 2000 .. 2250
9 2250 .. 2500
16
15
Assembly 8
Aer seng the height, the housing on the rotary switch must be sealed
with the aached transparent adhesive lm.
17. Sensor unit
The sensor unit must now be connected. To do this,
connect the connector cable to the distributor. You can
nd further details in the CO2 CONTROL gas warning
system operang instrucons.
17
18
8
16.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kundo xT CO2 Control AM Plus 2018 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kundo xT CO2 Control AM Plus 2018 in the language / languages: English as an attachment in your email.

The manual is 6,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kundo xT CO2 Control AM Plus 2018

Kundo xT CO2 Control AM Plus 2018 Installation Guide - German - 16 pages

Kundo xT CO2 Control AM Plus 2018 Installation Guide - Dutch - 16 pages

Kundo xT CO2 Control AM Plus 2018 Installation Guide - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info