639486
132
Zoom out
Zoom in
Previous page
1/143
Next page
104 REMOVING THE LOADER
REMOVING THE LOADER
To avoid personal injury:
A Make sure an approved bucket is attached
before removing the loader from the tractor.
A For removing the loader, choose flat and hard
ground, preferably concrete.
A If the ground surface is soft, place suitable
planks on the ground for the bucket and stand.
A When starting the engine or using the loader
control lever, always sit in the operator's seat.
A Make sure the bucket and stand are at ground
level.
1. Raise the boom until the stand can be rotated.
2. Stop the engine.
3. Remove the spring pin holding the stand to the boom.
4. Slide the stand leftward and rotate it until the hole in
the stand and pin on the boom are aligned.
Then slide the stand rightward and insert the spring pin
as shown.
5. Start the engine and run at idle.
6. Dump the bucket approximately 20 degrees.
7. Lower the boom and raise the front wheels slightly.
A Lift the front wheels with the bucket. Do not attempt to
lift them with the stand.
8. Stop the engine.
9. Remove the mounting pins from the loader side frame
and retain them in the plate of side frame.
(1) Stand
(2) Spring pin
(1) Stand
(1) Mounting pin
132


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kubota BX25DLB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kubota BX25DLB in the language / languages: English as an attachment in your email.

The manual is 8,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info