639486
50
Zoom out
Zoom in
Previous page
1/143
Next page
PRE-OPERATION CHECK OF THE LOADER22
TIRE INFLATION
Insure that the tractor tires are properly inflated.
See "TIRES, WHEELS AND BALLAST" section.
TEST OPERATION
To avoid serious personal injury:
A Keep engine speed at low idle during the test
operation.
A Escaping hydraulic fluid under pressure can
have sufficient force to penetrate skin, causing
serious personal injury.
Before disconnecting lines, be sure to relieve
all pressure by moving the controls.
Before applying pressure to the system, be
sure all connections are tight and that lines,
tubes and hoses are not damaged.
Fluid escaping from a very small hole can be
almost invisible. Use a piece of cardboard or
wood, rather than your hands to search for
suspected leaks.
If injured by escaping fluid, see a doctor at
once. Serious infection or allergic reaction will
develop if proper medical treatment is not
administered immediately.
A When the lever is at each corner position marked by
asterisk (*), boom and bucket cylinders work at the
same time. However, the blank position (Raise & Roll
back) is not recommended for scooping because of
insufficient lift force.
To begin test operation, slightly move the control lever
from "N" position. Slowly raise the loader boom just
enough for the bucket to clear the ground when fully
dumped. Slowly work through the dump and roll back
cycles.
A If the boom or bucket does not work in the directions
indicated on the label, lower the bucket to the ground,
stop the engine, and relieve all hydraulic pressure.
Recheck and correct all hydraulic connections.
This control valve has 2 stage dump positions. The first
"Regenerative" dump position, activated by moving the
lever to the right, features high speed for efficient normal
loader operations.
The second "Regular" dump position, activated by moving
the lever further to the right, features increased power.
This second position should be used when operating
implements other than the loader with this control valve.
These 2 positions are separated by a "Feel" position for
your convenience.
REMOVING AIR FROM HYDRAULIC
SYSTEM
Repeat raising and lowering the boom and bucket
operations until all the air is removed from the system and
the system responds properly.
A Do not move the control lever into float position when
the bucket is off the ground.
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kubota BX25DLB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kubota BX25DLB in the language / languages: English as an attachment in your email.

The manual is 8,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info