Manual Kubota B2320 (page 83 of 88) (English)

639537

Zoom out

Zoom in

1/88

67PERIODIC SERVICE

EVERY 2 YEARS

BFlushing Cooling System and Changing

Coolant

To avoid personal injury:

A Do not remove radiator cap while coolant is

hot. When cool, slowly rotate cap to the first

stop and allow sufficient time for excess

pressure to escape before removing the cap

completely.

1. Stop the engine, remove the key and let it cool down.

2. To drain the coolant, open the radiator drain cock, and

remove radiator cap. The radiator cap must be

removed to completely drain the coolant.

3. After all coolant is drained, close the drain cock.

4. Fill with clean soft water and cooling system cleaner.

5. Follow directions of the cleaner instruction.

6. After flushing, fill with clean soft water and anti-freeze

until the coolant level is just below the radiator cap.

Install the radiator cap securely.

7. Fill with coolant up to the "FULL" mark of recovery

tank.

8. Start and operate the engine for few minutes.

9. Stop the engine, remove the key and let cool.

10.Check coolant level of recovery tank and add coolant

if necessary.

11.Properly dispose of used coolant.

A Do not start engine without coolant.

A Use clean, fresh soft water and anti-freeze to fill the

radiator and recovery tank.

A When mixing the anti-freeze with water, the anti-freeze

mixing ratio is 50 %.

A Securely tighten radiator cap. If the cap is loose or

improperly fitted, water may leak out and the engine

could overheat.

BAnti-Freeze

To avoid personal injury:

A When using antifreeze, put on some protection

such as rubber gloves (Antifreeze contains

poison.).

A If should drink antifreeze, throw up at once and

take medical attention.

A When antifreeze comes in contact with the skin

or clothing, wash it off immediately.

A Do not mix different types of Antifreeze.

The mixture can produce chemical reaction

causing harmful substances.

A Antifreeze is extremely flammable and

explosive under certain conditions. Keep fire

and children away from antifreeze.

A When draining fluids from the engine, place

some container underneath the engine body.

A Do not pour waste onto the grounds, down a

drain, or into any water source.

A Also, observe the relevant environmental

protection regulations when disposing of

antifreeze.

If it freezes, coolant can damage the cylinders and

radiator. If the ambient temperature falls below 0

(32 ) or before a long-term storage, let out cooling water

completely, or mix fresh water with long-life coolant and fill

the radiator and recovery tank with the mixture.

1. Long-life coolant (hereafter LLC) comes in several

types. Use ethylene glycol (EG) type for this engine.

2. Before employing LLC-mixed cooling water, fill the

radiator with fresh water and empty it again.

Repeat this procedure 2 or 3 times to clean up the

inside.

3. Mixing the LLC

Put the LLC in cooling water in the percentage (%) for

a target temperature. When mixing, stir it up well, and

then fill into the radiator.

4. The procedure for the mixing of water and antifreeze

differs according to the make of the antifreeze and the

ambient temperature. Refer to SAE J1034 standard,

more specifically also to SAE J814c.

A When the antifreeze is mixed with water, the

antifreeze mixing ratio must be less than 50%.

Coolant capacity

(with recovery tank)

3.9 L (4.1 U.S.gals.)

(1) Radiator cap

(2) Recovery tank

(3) Drain cock

(A) "FULL"

(B) "LOW"

Vol %

Anti-freeze

Freezing Point Boiling Point*

-24

-37

-12

-34

106

108

222

226

my b 2320 is making a loud clicking sound from the drive line. I suspect it is a broken bearing in the transmission. Is this easily repairable
Submitted on 29-4-2023 at 11:54
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Kubota B2320 in the language / languages: English as an attachment in your email.

The manual is 5,46 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Kubota B2320 Manual

Product: