639537

Kubota B2320 Manual

31
Zoom out
Zoom in
Previous page
1/88
Next page
15OPERATING THE ENGINE
A Glow plug indicator (5) comes on while engine is being
preheated.
A [HST type]
Because of the safety devices, the engine will not start
except when the PTO gear shift lever is placed in the
"OFF" position, the speed control pedal is placed in the
"NEUTRAL" position, and the clutch pedal is
disengaged.
A [Manual transmission type]
Because of the safety devices, the engine will not start
except when the PTO gear shift lever is placed in the
"OFF" position, the main gear shift lever is placed in
the "NEUTRAL" position, and the clutch pedal is
disengaged.
C Cold Weather Starting
When the ambient temperature is below -5 (23 ) and
the engine is very cold. If the engine fails to start, turn off
the key for 30 seconds. Then repeat steps 8 and 9. To
protect the battery and the starter, make sure that the
starter is not continuously turned for more than 30
seconds.
BBlock Heater (Option)
A block heater is available as an option from your dealer.
It will assist you in starting your tractor when the ambient
temperature is below -15 (5 )
If a lamp is still on, immediately stop the engine and
determine the cause.
STOPPING THE ENGINE
WARMING UP
To avoid personal injury:
A Be sure to set the parking brake during warm-
up.
A Be sure to set all shift levers to the "NEUTRAL"
positions and to place PTO lever in "OFF"
position during warm-up.
For five minutes after engine start-up, allow engine to
warm up without applying any load, this is to allow oil to
reach every engine part. If load should be applied to the
engine without this warm-up period, trouble such as
seizure, breakage or premature wear may develop.
BWarm-up Transmission Oil at Low
Ambient Temperatures
Hydraulic oil serves as transmission fluid. In cold weather,
the oil may be cold with increased viscosity. This can
cause delayed oil circulation or abnormally low hydraulic
pressure for some time after engine start-up. This in turn
can result in trouble in the hydraulic system. To prevent
the above, observe the following instructions:
Warm up the engine at about 50 % of rated rpm according
to the table below:
A Do not operate the tractor under full load condition until
it is sufficiently warmed up.
8. Fully depress the clutch pedal, turn
the key to "PREHEAT" position and
hold it for about 2 to 3 seconds.
Temperature Preheating Time
Over 0 C (32 F) 2 to 3 sec.
0 to -5 C (32 to 23 F) 5 sec.
-5 to -15 C (23 to 5 F) 10 sec.
9. Turn the key to "START" position and
release when the engine starts.
10. Check to see that all the lamps on the
Easy Checker(TM) are "OFF".
11. Release the clutch pedal
1. After slowing the engine to idle, turn the
key to "OFF".
2. Remove the key.
Ambient temperature Warm-up time requirement
Above 0 C (32 F) At least 5 minutes
0 to -10 C (32 to 14 F) 5 to 10 minutes
-10 to -20 C (14 to -4 F) 10 to 15 minutes
Below -20 C (-4 F) More than 15 minutes
… 31 …


Need help? Post your question in this forum.

Forumrules
1

Forum

kubota-b2320

Reset search

  • my b 2320 is making a loud clicking sound from the drive line. I suspect it is a broken bearing in the transmission. Is this easily repairable
    Submitted on 29-4-2023 at 11:54

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kubota B2320 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kubota B2320 in the language / languages: English as an attachment in your email.

The manual is 5,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info