Manual Krups XP2000 expert combination (page 19 of 43) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

55434

Zoom out

Zoom in

1/43

• Ensure the drip tray and drip tray grid are in

place when using the machine.

Before First Use

Espresso

Before using your machine for the first time,

clean the system completely as follows:

• Open the lid and lift out the water container

using the handle (1). Fill the water container

with fresh, cold water (2).

• Place the water container back into the

machine by positioning it firmly in the water

container compartment (3) and close the lid.

• Turn on the machine by pressing button (N)

(4). The pump will work for 2 seconds to fill

the system with hot water for a cup a hot

coffee from the start.

• As soon as the appliance reaches the right

temperature, the orange temperature

control light switches off.

• Your espresso maker is equipped with

three filters designed for 1 cup, or for 2

cups of espresso using ground coffee, or

for E.S.E. (Easy Serving Espresso) pods.

The first comes in the filter holder (I),

the other two are found in the

appliance’s transport packaging.

• Choose the filter that you wish to use and

place it in the filter holder (5). Store the 2

others in the espresso lid (A).

• Then place the filter holder under the

appliance’s brewing head. To ensure that the

filter holder is in the correct position, turn

the handle so it points to the left at a 45

degree angle (6), place the filter holder flat

against the brewing head, then turn the

handle towards the right (7) as far as it can

go.

• Place a container, as large as possible,

beneath the filter holder (8).

The machine is ready to operate.

• By turning the control button to the right (O)

to espresso mode; the water will flow

through the pipes of the appliance (9).

• Let approximately 250 ml flow through, then

turn the control button (O) back to the

central position (10).

To start the coffee maker part, see the FILTER

COFFEE section.

Using the various functions of

your espresso machine

1. MAKING ESPRESSO

The appliance will pre-brew the coffee before

making each cup in order to bring out the full

flavour for a satisfying cup of coffee. The

pump will work for 3 seconds, stop for

3 seconds, then continue with the cycle until

the end of the process.

. WITH GROUND COFFEE

For best results, we recommend that you first

pre-heat the accessories (filter holder, filters

and cups) without putting in ground

coffee. To do this:

• Fill the water container with fresh, cold

water (1) (2) (3) and turn on the machine

(4).

• Put the filter holder and an empty filter in

place (6) (7), and place the espresso cups

underneath.

• As soon as the appliance reaches the right

temperature, the orange temperature

control light switches off.

• Turn the control button (O) to espresso

mode (9). Take the pre-brewing into

account.

• The cups will fill with hot water. Once filled,

turn the button (O) back to the central

position and empty the cups.

After making your first espresso and the

machine is warmed, the espresso cups can

then be pre-heated on the cup warming plate.

. Preparing an espresso:

• Fill the water container (1) (2) (3) and turn

on the machine (4).

• Put the filter for one or two cups into the

filter holder (5).

• Place some ground coffee in the filter (1 or 2

measuring scoops), and then tamp it down

firmly; the coffee should reach the lip of the

filter (11) (12).

• Remove any ground coffee which is lying

around the filter (13).

• Replace the filter holder into the machine.

Turn the filter holder until it is firmly locked

into place (6) (7).

• Place one or two espresso cups beneath the

filter holder’s coffee outlets.

XP 2000 anglais.P65 10/01/06, 14:5121

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Krups XP2000 expert combination in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,62 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Krups XP2000 expert combination Manual

Product: