713137
6
Zoom out
Zoom in
Previous page
1/36
Next page
6
TROUBLESHOOTING
GUARANTEE
Possible problems Probable causes Corrective actions
The appliance will not start,
the ON/OFF button ashes.
The temperature of the jug
is too high
Wait for the light to stop
ashing and press the
ON/OFF button again
The stirrer is blocked Empty out the milk, remove
the stirrer and clean your
jug and stirrer.
Water has leaked into
the base of the appliance
during cleaning.
Leave to dry 24 hours.
The appliance is not
frothing.
The stirrer is missing or is
not positioned correctly.
Empty out the milk and
reposition the stirrer.
Motor operates intermittenly
during entire frothing
process.
Water has leaked into
the base of the appliance
during cleaning.
Leave to dry 24 hours.
This product has been designed for domestic use only. Any commercial use, inappropriate
use or failure to comply with the instructions, the manufacturer accepts no responsibility
and the guarantee will not apply.
If you have any questions, please contact the customer service of your country. It is
preferable to have the appliance close to hand when calling, as well as the serial number
marked on the bottom of the appliance.
If you have any problem problems or queries, please contact our Customer Relations Team
rst for expert help and advice:
0345 330 6460 - UK, (01) 677 4003 - Ireland, or consult our website - www.krups.co.uk
This product contains an electronic board in the base, any introduction of water or other
liquid in this part could damage the product. In this case the guarantee will not apply.
If the problem continues, please contact the service centre in your country.
CLEANING: DO NOT CLEAN THE APPLIANCE
IN A DISHWASHER
The non-stick coating on the inside of the jug means that you can clean it easily. Here’s how
to go about it: Unplug the appliance.
1. Remove the stirrer from the jug (fig 4).
2. Clean the jug using warm water and washing-up liquid with a sponge or a non-abrasive
cleaner (fig 5).
3. Never immerse the appliance in water or put it under running water (fig 6).
4. Dry the appliance.
Remember to t the stirrer again, ensuring that it is clipped into place.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups XL1008 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups XL1008 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info