380081
3
Zoom out
Zoom in
Previous page
1/4
Next page
3
How to proceed if ...
...you want to
correctly care for
and clean your
dryer:
Clean the filter at the end of
every cycle.
Open the door.
Pull the filter upwards.
Open the filter.
Brush lint using a soft brush or your fingertips.
Close the filter.
Push the filter back into place.
Empty the water container at
the end of each drying cycle.
Pull the handle to remove the water container.
Empty the water container.
Replace the water container when empty by
pushing it
completely
back in place.
Clean the heat exchanger at
least every month.
(For further information see
chapter “Heat Exchanger” in
the Instructions for Use).
Remove fibres in and around the water
evacuation hole at least once per month.
...you want to check
the dryer yourself
first:
(If your machine is not
functioning correctly,
please check the
following points before
phoning for the
customer service – also
refer to relevant chapter
in the instructions for
use)
Drying takes too long / laundry
is not dry enough.
Has the correct drying programme been
selected?
Was the inserted laundry too wet (washing
machine spin speed less than 1000 rpm)?
Is the lint filter dirty (filter indicator light on)?
Is the heat exchanger dirty? (for more
information, refer to the instructions for use)
Is the room temperature too high?
Are the “End” “ ” and “Anti-crease”
” indicator lamps lighting up? The
drying cycle is complete and the laundry can be taken out.
If the drying result does not meet your
expectation, select a more dry programme.
The dryer will not operate
(after a power failure, always
press the “Start (Pauze)”
button).
Is the plug properly inserted into the mains
electricity socket?
Is there a power failure?
Has the fuse blown?
Is the door properly closed?
Has a drying programme been selected?
•Has the
“Start (Pauze)”
button been pressed?
Has the start-delay option been selected?
Is the dryer overloaded? Please remove a part
of the load.
Lint filter or water container
indicator lamp on.
Is the lint filter clean?
Is the water container empty?
Has the water container been inserted correctly?
Is the heat exchanger clean?
Water droplets underneath
the dryer.
Has the heat exchanger been inserted correctly?
Has any fluff on the heat exchanger seal been
wiped away?
Has any fluff on the door seal been wiped away?
Has the water container been inserted
correctly?
Replacing the drum light bulb
(if supplied).
If the inside lamp does not work, the bulb may
be faulty.
•Unplug the dryer.
Open the door and unscrew the glass cover
inside the drum.
Replace the faulty bulb with a new one and
screw the glass cover back on.
Replacement bulb: Philips 15W, 230/240V, E14.
All programme sequence
indicators blinking.
Service call necessary.
AFTER-SALES SERVICE
If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the machine off.
Please contact your After-Sales Service representative (for more information, refer to the warranty manual).
Please have the following details ready when calling your after-sales service representative:
The nature of the fault.
The dryer type and model.
The service code (the number after the word Service on the adhesive rating
plate) on the right-hand side when the door is open.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups variomix 3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups variomix 3000 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info