672686

Krups EVIDENCE EA89011 Manual

32
Zoom out
Zoom in
Previous page
1/306
Next page
The machine asks for the drip
tray to be emptied although it is
not full.
The machine is programmed to ask for the drip tray to be emptied after a certain
number of coffees despite any intermediate emptying operations that you may
complete.
The appliance asks to be
unplugged and plugged back in
again.
Unplug the appliance for 20 seconds, remove the Claris Aqua Filter System
cartridge if necessary, then plug it back in again.
If the error continues, contact the KRUPS Customer Service team.
The machine does not request
descaling.
The descaling cycle is requested after the steam circuit has been used a
signicant number of times.
Some ground coffee has found
its way into the drip tray.
A small amount of ground coffee may settle in the drip tray. The machine is
designed to evacuate any excess ground coffee so that the percolation zone
remains clean.
The milk or water is not owing
correctly into the cup(s).
Check that the One Touch Cappuccino block is correctly positioned.
There are traces of milk in an
Americano or a Hot water.
Complete a milk rinsing cycle or dismantle and clean the one touch cappuccino
accessory before running the preparation.
There is water underneath the
appliance.
Before removing the water tank, wait for 15 seconds after the coffee has
nished owing so that the appliance nishes its cycle properly. Check that the
drip tray is correctly positioned on the machine; it should always be in place,
even when the appliance is not in use. Check that the drip tray is not full.
The drip tray should not be removed during a cycle.
When you turn off the appliance,
warm water ows out of the
coffee outlets and the One Touch
Cappuccino block.
According to the type of recipe prepared, the machine may run an automatic
rinsing cycle when it is turned off. This cycle lasts only a few seconds and stops
automatically.
After emptying the coffee
grounds collector, the warning
message is still displayed on the
screen.
Correctly replace the coffee grounds collector and follow the instructions on
the screen.
Wait at least 5 seconds before replacing them.
The coffee dispenses too slowly.
Turn the ‘neness of grind’ adjustment dial to the right to make the ground
coffee coarser (according to the type of coffee used).
Run one or several rinsing cycles.
Run a machine clean (see “Automatic machine cleaning programs p.28).
Change the Claris Aqua Filter System cartridge (see “Installing the lter”) p. 23).
The water tank has been lled,
but the warning message is still
displayed on the screen.
Check that the tank is installed correctly on the device.
The oat at the bottom of the tank should move freely. Check and unblock the
oat if necessary.
The coffee neness knob is
difcult to turn.
Only change the grinder setting when it is running.
The espresso or coffee is not hot
enough.
Run a coffee circuit rinsing cycle before preparing your coffee.
Increase the coffee temperature in the Settings menu. Warm the cup by rinsing
it with hot water before making the drink.
30
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EVIDENCE EA89011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EVIDENCE EA89011 in the language / languages: All languages as an attachment in your email.

The manual is 2,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info