536769
21
Zoom out
Zoom in
Previous page
1/37
Next page
21
water hardness to assess the frequency of
descaling of your appliance in normal use.
Descaling depends on the hardness of the
water, but also on the use cycle. The frequently
of descaling indicated by the 054 accessory is
thus given by way of indication only.
- Then follow the following method:
Unscrew the grid from the head of the
appliance and clean it.
Dissolve 2 dessertspoons of the descaling
product or a sachet of KRUPS descaling
accessory, reference 054, in half a litre of
lukewarm water and pour the whole lot into
the empty water tank.
Place a container under the brewing head.
Run through about 1/3 of the liquid
immediately, setting the selector to the
position (10).
Stop the appliance, leaving the
position
(10) engaged and wait for 10 - 15 minutes
to allow the descaler to take effect.
Next, start the machine again and allow the
rest of the liquid to run through.
Then rinse with two water tanks of fresh
water and replace the grid on the head of the
appliance (see paragraph on maintenance).
Problems, probable causes and
how to correct them
Problems Probable causes Corrective actions
Espresso not hot Cups, filter and Preheat the
enough filter holder accessories (cups,
are cold. filter, filter holder)
See paragraph
«Preparing an
espresso».
Coffee leaks The filter holder See paragraph
around the filter is not mounted «Preparing an
holder correctly or has espresso».
not been tightened
sufficiently.
There are coffee Clean around the
grounds on the filter and the
edge of the filter gasket.
The brewing head Clean the gasket
gasket is dirty. with a damp cloth.
The brewing Contact an
head gasket approved Krups
is defective service centre.
Pump is very noisy No water in the Fill the water tank.
water tank.
Water tank incor- Press firmly down
rectly mounted. on the water tank.
Coffee grounds too Use fresh coffee
old or very dry
and the pump can-
not produce
pressure.
Water does not run No water in the Fill the water tank.
through water tank. Press firmly down
Water tank incor- on the water tank.
rectly mounted.
The filter is blocked, Clean the filter and
the coffee grounds the grid on the
are too fine or head.
tamped down too See the paragraph
hard. «Maintenance»
and try a coarser
coffee.
Brewing head Put the grid to
grid is encrusted soak in descaling
solution
See paragraph
«Maintenance».
Appliance needs See paragraph
descaling. «Descaling».
Water runs through Coffee grounds too Try a finer coffee
too quickly coarse
Quantity of Use the spoon
ground coffee provided to
is insufficient. measure out the
coffee.
Coffee grounds not Tamp down the
tamped down coffee again.
firmly enough
The espresso has Coffee grounds Try a finer-ground
no froth (froth on too coarse coffe
coffee)
Coffee grounds Tamp down the
not tamped coffee again
Coffee grounds Use fresh coffee
stale or too dry
FNC1/2/3.PM6.5 19/01/04, 16:1721
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups Espresso Novo Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups Espresso Novo Plus in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info