690034

Krups EA85 serie Manual

27
Zoom out
Zoom in
Previous page
1/170
Next page
29
EN
Emptying the coffee grounds collector, coffee drawer and the
drip tray
After a certain number of coffees, the machine will ask you to empty the coffee grounds
collector and to clean the coffee drawer. Failure to perform these operations correctly can
damage your appliance.
The drip tray collects the used water and the coffee grounds collector collects the used
coffee grounds.
The coffee drawer allows you to remove any coffee grounds below the percolation chamber.
If the message “Empty the two trays” is displayed, empty and clean the drip tray.
1. Remove, empty and clean the coffee grounds collector. Fig. 21.
2. Remove the coffee drawer.
Wait for at least 8 seconds, then first put the coffee drawer back in place and then the coffee
grounds collector tray. Fig. 22.
The drip tray is equipped with a float indicating when it requires emptying.
The machine is programmed to ask for the drip tray to be emptied after a certain number
of coffees, irrespective of the number of times you may have emptied the tray already.
Circuit rinsing
You can perform a rinse at any time by pressing Prog then maintenance. Depending on the
types of recipes prepared, the appliance can perform an automatic rinse when switching
off.
It is also possible to set automatic rinsing on switch-on (see "Settings" section page 24).
Automatic clean programmes
Automatic clean programme for the coffee circuit
The appliance will tell you when a clean programme is required. This clean must take place
every 360 preparations approximately.
To perform the clean programme, you will need a container with a capacity of at least 0.6 litre;
this should be placed under the coffee outlets and you will need a KRUPS cleaning tablet.
Follow the instructions on-screen. It is also possible to launch cleaning via the maintenance
menu.
Important: you do not have to perform the clean programme immediately when the
appliance requests this; however, you should do this as soon as possible. If
cleaning is delayed, an alert message will remain on the screen until the
operation is performed.
The automatic clean programme includes two phases: a clean and a rinse cycle; the
programme takes about 13 minutes.
Important: if you disconnect your appliance during cleaning or in the event of a power
cut, the cleaning programme will resume the stage in progress during the
incident. It will not be possible to delay this operation. It is mandatory due to
water circuit rinse reasons. In this case, a new cleaning tablet may be
required. Run the entire cleaning programme to eliminate all traces of cleaning
product that may be harmful to health.
Do not place your hands under the coffee outlets during the cycle.
GENERAL MAINTENANCE
!
!
IFU_KR_EA85_EO_0A17613_EA85 10/09/13 11:33 Page29
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EA85 serie at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EA85 serie in the language / languages: English, German, Dutch, French, Italian, All languages as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info