672694

Krups EA82FD - QUATTRO FORCE Manual

31
Zoom out
Zoom in
Previous page
1/184
Next page
problem malfunction corrective actions
The appliance does not switch on when the
ON/OFF button is pressed.
Turn off and unplug the machine, remove the lter cartridge, wait for
20 seconds and then restart the machine. Ensure that the plug on the
electrical cable is fully inserted into the power socket.
Water or steam issue from the steam nozzle.
In the case of repeated uses, a few drops may issue from the steam
nozzle.
The appliance is working but no liquid is coming
out.
Check that the water container is in the correct position and that the cord
is not jammed between the appliance itself and the water container.
The espresso or coffee is not hot enough.
Change the coffee temperature setting. Heat the cups by rinsing under hot
water.
The coffee is too lightly coloured or too weak.
Check that the coffee bean container holds coffee and that this is owing
correctly.
Avoid using oily, caramelised or avoured coffee beans.
Reduce the volume of coffee using the central button.
Turn the grinding neness button to the left to obtain more nely ground
coffee.
Carry out your preparation over two cycles by using the two-cup function.
The coffee is poured too slowly or not at all.
Turn the grinding neness button to the right to obtain more coarsely
ground coffee (may depend on the type of coffee used).
Carry out one or more rinsing cycles.
Run a damp sponge beneath the coffee outlet.
The coffee is not creamy.
Turn the grinding neness button to the left to obtain more nely ground
coffee (may depend on the type of coffee used).
Change the Claris - Aqua Filter System cartridge (follow the installation
procedure on page 3).
Carry out one or more rinsing cycles.
The appliance has not produced coffee.
An incident has been detected during preparation.
The appliance has automatically restarted and is ready for a new cycle.
You have used ground coffee instead of coffee
beans.
Use your vacuum cleaner to remove the pre-ground coffee from the coffee
bean container.
The coffee grinder makes a strange noise.
There are foreign bodies present in the grinder. Contact the KRUPS
Customer Service team.
The grinding neness setting button is difcult
to turn.
Only modify the grinding neness setting when it is in operation. There
are foreign bodies present in the grinder: contact the KRUPS Customer
Service team.
The steam nozzle of your cappuccino system
seems partially or completely clogged.
Disassemble the nozzle using the dismantling key. Fig. 44
Start the cappuccino system rinsing cycle to remove the remainder of the
deposits.
Clean the steam nozzle and ensure that the opening of the nozzle is not
obstructed by remains of milk or limescale. Use the cleaning needle if
necessary.
The cappuccino system does not suck the milk.
The cappuccino system makes little or no froth.
Check that the appliance is correctly assembled.
Ensure that the setting button is in the CAPPUCCINO position.
Ensure that the steam nozzle is not blocked.
Ensure that the air nozzle is in place and correctly assembled. The air
nozzle (Fig. 42) may be blocked; leave it to soak in hot water and some
washing up liquid, and then rinse prior to reassembly.
Ensure that the exible pipe is not blocked or twisted and that it is properly
inserted into the cassette to avoid any air leak.
Ensure the milk suction pipe is fully immersed in the milk.
Rinse and clean the system (see corresponding sections).
For milk-based preparations: we recommend that you use very fresh, very
cold pasteurised or UHT milk, recently opened. Unpasteurised milk does
not produce the best results. It is also recommended that you use a cold
container.
After having washed the coffee drawer
(1)
, the
warning message is still displayed on the screen.
Remove the drawer, wait for six seconds, then replace it. Wipe clean the
area where the coffee drawer
(1)
sits and ensure the coffee drawer
(1)
is
correctly installed.
29
EN
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EA82FD - QUATTRO FORCE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EA82FD - QUATTRO FORCE in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info