690029
30
Zoom out
Zoom in
Previous page
1/187
Next page
25
ENGLISH
PROBLEMS CORRECTIVE ACTIONS
The steam does not come
out of the nozzle.
After switching off your appliance and leaving it to cool:
Make sure the tip of the steam nozzle is properly
afxed. Make sure the steam nozzle is not clogged at
the aerator (if necessary clean the steam nozzle aerator
with the needle supplied). Empty the tank and remove
the Claris lter. Fill the tank with mineral water high in
calcium (> 100 mg/litre or .015oz/gallon), it may take as
many as 5 to 10 cycles of steam at 60 seconds each
cycle to achieve a continuous jet of steam.
There is not enough milk
froth.
Using the needle supplied unblock the small air inlet at
the top of the nozzle if required.
Use a cold container and milk that has been opened
recently.
Try changing the type of milk if this does not work (UHT
or pasteurised).
The milk froth is too bubbly.
Check that the two ends of the small stainless steel
tube are tted correctly into the exible part of the
steam nozzle.
The Auto-Cappuccino
accessory does not suck
the milk (accessory sold
separately).
Ensure that the tube immersed in the milk is not
blocked.
Check that the exible tube is not twisted and that it is
correctly tted into the accessory to avoid any air being
sucked in.
After switching off your appliance and leaving it to cool,
unblock the outlet of the Auto-Cappuccino accessory.
After emptying the coffee
grounds collector, the
warning message is still
displayed on the screen.
Correctly replace the coffee grounds collector and
follow the instuctions on the screen. Wait at least 6
seconds before replacing them.
The power has been cut off
during a cycle.
The appliance resets itself automatically when the
power is switched back on and is ready for a new cycle.
There is water or coffee
underneath the appliance.
The drip collector tray has overowed: empty it and
clean the coffee grounds collector. Check that the drip
tray is tted correctly.
Do not remove the water tank before the end of the
cycle.
A message appears.
Unplug the appliance for 20 seconds, remove the Claris
cartridge and if required, put it back into service.
If the fault persists, note the fault number and contact
KRUPS’ Customer Service.
If coffee ows behind the
coffee nozzles.
Pour cold or room-temperature water into the tank.
Reduce the temperature level.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EA82 serie at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EA82 serie in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 1,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info