711468

Krups EA8161 Manual

21
Zoom out
Zoom in
Previous page
1/156
Next page
21
EN
Installation of the lter cartridge - total duration: around 2 min
To get the best taste from your coffee and extend your appliance’s service life, we advise you to use only the Claris -
Aqua Filter System cartridge sold as an accessory.
Fig. 30 : Mechanism to indicate the month the cartridge was tted and when to replace it (after 2 months at most).
Installing the cartridge in the appliance. On rst use, screw the lter cartridge into the bottom of the water tank - Fig. 31.
Place a 0.6 l container under the steam nozzle.
Press the button for more than 3 seconds (unless the appliance requires a ‘CLEAN’ and/or ‘CALC’ maintenance).
The indicator light ashes.
When the installation of the lter cartridge is nished, the indicator light becomes constant.
Your appliance is ready for the next use.
The Claris cartridge needs to be replaced after about every 50 litres of water or every two months at least. If you are
using the Claris – Aqua Filter System cartridge, set the water hardness to level 0.
Settings
Connect the appliance to the mains power supply but do not turn it on.
Lift the cup grid by pressing on the back to make it tilt - Fig. 25.
Press the and simultaneously - Fig. 27.
The digital display for parameter setting is under the servicing ap - Fig. 28.
Look down vertically to the bottom of the window - Fig. 29.
Proposed settings order:
1. Adjust water hardness
2. Adjust coffee temperature
3. Adjustment of the auto-off function
4. Info
1. Setting water hardness
Appliances are pre-set in the factory for hardness level 4.
Before using the appliance for the rst time or if you have noted a change in water hardness, it is advisable to adapt the
appliance to the water hardness. Please contact your water supplier to nd out the water hardness in your area.
Degree of
hardness
0
Verv soft
1
soft
2
moderately hard
3
hard
4
extremely hard
° f < 5,4° > 7,2° > 12,6° > 25,2° > 37,8°
°dH < 3° > 4° > 7° > 14° > 21°
°e < 3,75° > 5° > 8,75° > 17,5° > 26,25°
Settings 0 1 2 3 4
The “water tank” light will come on.
Press the button - Fig. 32 as many times as are needed to select the hardness level for the water used: 0 = very
soft, 1 = soft, 2 = moderately hard, 3 = hard, 4 = very hard.
To go to the next phase, press the button or to leave the settings mode press .
2. Setting the coffee temperature
Appliances are pre-set in the factory to level 2.
The ‘CALC’ light comes on.
Press the - Fig. 32 button as many times as are needed to adjust the desired coffee temperature: 1, 2 or 3.
To go to the next phase, press the button or to leave the settings mode, press .
3. Setting the automatic electrical power supply cut-off (auto-off)
Appliances are pre-set in the factory to 1 hour.
You can set your appliance to turn off after a pre-programmed number of hours.
The ‘CLEAN’ light comes on.
Press the - Fig. 32 button as many times as necessary to select the desired duration: 1 = 1h, 2 = 2h, 3 = 3h, 4 = 4h.
To go to the next phase, press the button, or to leave the settings mode, press .
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EA8161 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EA8161 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 2,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info