8
If the light comes
on, remove, empty and
clean the drip tray.
The drip tray receives waste water and the coffee grounds collector receives used coffee grounds.
The coffee cleaning tray allows you to eliminate any deposits of coffee grounds.
Remove, empty and
clean the coffee
grounds collector.
The drip tray is equipped
with floats to tell you
when to empty it.
The light will remain on if the coffee grounds collector is not slotted in fully or not fitted correctly or if
it has been put back in less than 4 seconds. You cannot make espresso or coffee while the light is on or is
flashing. The coffee grounds collector has a capacity of 9 coffees.
MAINTAINING YOUR APPLIANCE
As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow.
MACHINE CLEANING PROGRAM – TOTAL DURATION: ABOUT 20 MINUTES
When a cleaning operation is necessary, the appliance warns you of this by flashing the "clean" light.
This program is only accessible when the machine requests it (i.e. approximately every 300 coffees or espressos).
Press the ‘Service’
button to start up the
cleaning program.
The ‘clean’ and
lights will flash.
Empty and clean the
coffee grounds collector
then fit it again.
The light will go off.
Remove and clean
the cleaning tray then
fit it again.
Remove, fill and re-fit
the water tank.
RINSING OUT THE CIRCUITS: SEE PAGE 5
Place a receptacle with a
minimum capacity of 0.6 l
under the coffee outlets.
Remove the coffee
cleaning tray.
Clean it under water
and dry thoroughly.
Caution! To benefit from the guarantee conditions, it is essential to perform the appliance cleaning cycle
when informed to do so. Be sure to follow the procedure closely, step by step.
You can continue to use the appliance when the light is on, but you are advised to perform the program as soon as possible.
Remove and empty the
drip tray.
EMPTYING THE COFFEE GROUNDS COLLECTOR, THE COFFEE TRAY
AND THE DRIP TRAY
ENGLISH