711474

Krups EA815 Manual

31
Zoom out
Zoom in
Previous page
1/144
Next page
29
If one of the problems described in the table persists, contact KRUPS customer service.
PROBLEM MALFUNCTION CORRECTIVE ACTION
Your machine detects a fault:
a symbol appears.
Switch off and disconnect the machine, remove the filter cartridge, wait for a
minute and restart the machine.
The appliance does not turn
on when the button is
pressed.
Check your fuses and plug sockets.
Check that the two power plugs are pushed in properly both on the appliance
and at the socket.
The coffee grinder makes a
strange noise.
There is a foreign body in the grinder. Disconnect the machine before inves-
tigating.
See if you can extract the foreign body using your vacuum cleaner.
The steam nozzle makes a
noise.
Check that the steam nozzle is correctly attached to its corresponding end
piece.
The steam nozzle on your
machine seems partially or
completely clogged.
Ensure that the opening in the end piece is not obstructed by milk residue or
limescale. Unclog the holes with the needle supplied with your appliance.
The steam nozzle makes little
or no milk froth.
For milk-based drinks, you use very fresh, very cold pasteurised or UHT milk.
It is also advisable to use a cold container. If the results do not improve, try
changing the brand of milk.
No steam comes out of the
nozzle.
Empty the tank and temporarily remove the filter cartridge. Fill the water tank
with mineral water which is high in calcium (> 100 mg/l) and run successive
steam cycles.
The auto-cappuccino setting
makes little or no froth.
The auto-cappuccino setting
does not take in milk.
Check that the accessory is correctly attached to the appliance, remove it
then replace it.
Check that the flexible tube is not obstructed or pierced and that it is correctly
attached to the accessory so as to make it airtight. Rinse and clean the ac-
cessory (refer to the “Auto-cappuccino accessory” chapter).
There is water underneath the
appliance.
Before removing the water tank, wait for 15 seconds after the coffee has fini-
shed flowing so that the machine finishes its cycle properly.
Check that the drip tray is correctly positioned on the machine; it should
always be in place, even when the appliance is not in use.
Check that the drip tray is not full.
The drip tray should not be removed during a cycle.
After emptying the coffee
grounds collector, the warning
message is still displayed on
the screen.
Correctly replace the coffee grounds collector and follow the instructions on
the screen.
Wait at least 8 seconds before replacing them.
TROUBLESHOOTING
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EA815 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EA815 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 2,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info