561498

Krups EA6990 Manual

18
Zoom out
Zoom in
Previous page
1/120
Next page
KRUPS SERIE EA69xx
16
The coffee is not creamy enough. Turn the grinding fineness knob towards the left for a finer grind
(may depend on the type of coffee used).
Change the Claris Aqua Filter System cartridge (follow the ins-
tallation procedure on page 3).
Carry out one or two rinsing cycles.
The appliance does not serve any
coffee.
An incident has been detected during the preparation.
The appliance resets itself automatically and is then ready for a
new cycle.
You have used ground coffee
instead of coffee beans.
Use your vacuum cleaner to suck out the pre-ground
coffee in the coffee bean tank.
The grinder makes a strange noise. There are foreign particles in the grinder.
Contact KRUPS Customer Service.
The grinding fineness knob is hard to
turn.
Only change the grinder setting when it is operating.
The steam does not come out of the
nozzle.
After switching off your appliance and leaving it to cool:
Make sure the tip of the steam nozzle is properly affixed. Make
sure the air inlet on the steam nozzle is not clogged at the ae-
rator (if necessary clean the air inlet with the needle supplied).
Empty the tank and remove the Claris filter. Fill the tank with mi-
neral water high in calcium (> 100 mg/litre or .015oz/gallon), it
may take as many as 5 to 10 cycles of steam at 60 seconds
each cycle to achieve a continuous jet of steam. Once you have
a continuous jet of steam you should not have to use this par-
ticular type of water again.
There is not enough milk froth. Using the needle supplied unblock the small air inlet at the top
of the nozzle if required.
Use a cold container and very fresh, very cold milk that has been
opened recently.
Try changing the type of milk if this does not work (UHT or pas-
teurised).
The milk froth is too bubbly. Check that the two ends of the small stainless steel tube are fit-
ted correctly into the flexible part of the steam nozzle.
The Auto-Cappuccino accessory
does not suck the milk (accessory
sold separately).
Ensure that the tube immersed in the milk is not blocked.
Check that the flexible tube is not twisted and that it is
correctly fitted into the accessory to avoid any air being sucked in.
After switching of your appliance and leaving it to cool, unblock
the outlet of the Auto-Cappuccino accessory.
After filling the water tank, the
warning message is still displayed.
Check that the tank is fitted correctly onto the coffee
machine.
Check that the float at the bottom of the tank moves freely.
Rinse the tank and descale if necessary.
The cleaning or descaling programme
will not start.
Unplug the appliance for 20 seconds then switch it back on.
IFU_KR_COFFEEMAKER_EA69xx_0828344_EN 17/06/10 16:52 Page16
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EA6990 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EA6990 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 1,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info