111147

Krups EA 8050 Manual

9
Zoom out
Zoom in
Previous page
1/16
Next page
15
EN
Caution! To benefit from the guarantee conditions, it is essential to perform the appliance cleaning cycle when
informed to do so. Be sure to follow the procedure closely, step by step.
You can continue to use the appliance when the light is on, but you are advised to perform the program as soon as
possible.
Press the
button to start up the cleaning program. The ‘
CLEAN
’ and ‘ ’ lights will ash.
Remove and clean the cleaning tray then t it again
- Fig. 23
.
Empty and clean the coffee grounds collector then t it again
- Fig. 24
. The ‘ ’ light will go off.
Remove and empty the drip tray
- Fig. 25
.
Remove, ll and re-t the water tank.
Place a receptacle with a minimum capacity of 0.6 l under the coffee outlets
- Fig. 26
.
Open the servicing ap and insert a KRUPS cleaning tablet (XS3000) in the cleaning inlet
- Fig. 27
.
Press the button to start up the cleaning program.
1 - Cleaning cycle ± 10 mn
The ‘
CLEAN
’ light becomes steady. The cleaning cycle will be run automatically. The pump sucks up water
intermittently. This operation lasts about 10 minutes and the ‘
CLEAN
’ light will ash again.
Empty your waste water receptacle and put it back under the coffee outlets.
Again press the button to start the rst rinsing cycle.
2 - Rinsing ± 3 mn
The ‘
CLEAN
’ light will become steady again. The program continues. A rst rinsing cycle will be run automatically.
It allows the appliance to be rinsed and remaining detergent to be eliminated. This rst rinsing cycle lasts about
3 minutes and once nished the ‘
CLEAN
’ light will ash again.
Remove and empty your waste water receptacle.
Empty the drip tray and t it again.
Fill your water tank.
Your appliance will be ready for use again.
Only use KRUPS (XS3000) cleaning tablets. We cannot be held responsible for any damage that may result from the use
of tablets from other brands.
You can obtain cleaning tablets from KRUPS Service Centres.
Scale removal program – total duration: about 20 minutes.
The quantity of scale deposited depends on the hardness of the water used. The appliance will automatically warn you by
the ‘
CALC
’ light coming on when you need to proceed with scale removal.
This program is only accessible when the machine requests it.
Caution! To benefit from the guarantee conditions, it is essential to perform the appliance scale removal
cycle when informed to do so. Be sure to follow the procedure closely step by step.
You can continue to use the
appliance when the light is on, but you are advised to perform the program as soon as possible.
If your appliances fitted with our Claris - Aqua Filter System F088 cartridge, please remove the cartridge
during the descaling operation.
Make certain to protect your work surface during cleaning and scale removal cycles, especially if it is made
of marble, stone or wood.
Press the key to start up the scale removal program. The ‘
CALC
’ and ‘ ’ lights will ash.
Remove and clean the drip tray.
Place a receptacle with a minimum water capacity of 0.6 l under the coffee outlets and under the steam nozzle.
Empty the tank and ll it with lukewarm water up to the ‘
CALC
’ marking.
Dissolve a sachet of
Krups
scale remover
F054
(40 g).
Only use KRUPS scale removal products. You can obtain scale removal products from KRUPS Service Centres.
The manufacturer may not be held responsible for damage to the appliance through use of other products.
Put the water tank back in place. The ‘ ’ light turns off and the ‘
CALC
’ light stops blinking.
If there is not enough water in the water tank when you start the program, the ‘ ’light will come on to warn you.
Add the appropriate amount of water to the container and cleaning will continue automatically.
If your machine is unplugged during cleaning or in the event of power failure, you will have to restart the cleaning
program right from the start. This is essential due to water circuit rinsing reasons. In this case, you will need to use
another cleaning tablet. Be sure to complete the entire cleaning cycle to avoid any risk of irritation (seek medical
advice if cleaning solutions are accidently swallowed.
The cleaning cycle is a continuous cycle. Do not put your hands under the coffee outlets during the cycle.
… 9 …


Need help? Post your question in this forum.

Forumrules
1

Forum

krups-ea-8050

Reset search

  • Hoe demonteer ik de in hoogte verstelbare kofiiepijpjes van mijn krups quartro koffiemachine Submitted on 12-1-2022 at 14:20

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EA 8050 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EA 8050 in the language / languages: English as an attachment in your email.

The manual is 2,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Krups EA 8050

Krups EA 8050 User Manual - English - 12 pages

Krups EA 8050 User Manual - German - 330 pages

Krups EA 8050 User Manual - German, Dutch - 12 pages

Krups EA 8050 User Manual - Dutch - 16 pages

Krups EA 8050 User Manual - French - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info