111204
11
Zoom out
Zoom in
Previous page
1/16
Next page
17
EN
SWITCHING OFF
You can stop your appliance at all times: the appliance will emit two beeps and then it will stop soon afterwards.
The steam nozzle on your
machine seems partially or
completely clogged.
Ensure that the opening in the end piece is not obstructed by milk residue or
limescale. Unclog the holes with the needle supplied with your appliance.
The steam nozzle makes little or no
milk froth.
For milk-based drinks, you use very fresh, very cold pasteurised or UHT milk. It is
also advisable to use a cold container. If the results do not improve, try changing
the brand of milk.
No steam comes out of the nozzle.
Empty the tank and temporarily remove the lter cartridge. Fill the water tank with
mineral water which is high in calcium (> 100 mg/l) and run successive steam
cycles.
The auto-cappuccino set makes
little or no froth.
The auto-cappuccino set does not
take in milk.
Check that the accessory is correctly attached to the appliance, remove it then
replace it.
Check that the exible tube is not obstructed or pierced and that it is correctly
attached to the accessory so as to make it airtight. Rinse and clean the accessory
(refer to the “Auto-cappuccino accessory” chapter).
There is water underneath the
appliance.
Before removing the water tank, wait for 15 seconds after the coffee has nished
owing so that the machine nishes its cycle properly.
Check that the drip tray is correctly positioned on the machine; it should always
be in place, even when the appliance is not in use.
Check that the drip tray is not full.
The drip tray should not be removed during a cycle.
After emptying the coffee grounds
collector and cleaning the coffee
drawer, the warning message is still
displayed.
Correctly replace the coffee drawer and the coffee grounds collector, follow the
instructions on the screen.
Wait at least for 6 seconds before replacing them.
The coffee dispenses too slowly.
Turn the coffee neness knob to the right to make the grounds courser (this could
also depend on the type of coffee used).
Run one or several rinsing cycles.
Change the Claris Aqua Filter System cartridge (see “Installing the lter”).
The water/steam is not dispensed
normally from the steam nozzle.
At the beginning or end of making a drink, the steam nozzle may drip slightly.
The coffee neness knob is difcult
to turn.
Only change the grinder setting when it is running.
The espresso or coffee is not hot
enough.
Change the coffee temperature setting. Warm the cup by rinsing it with hot water
before making the drink.
The coffee is too lightly coloured or
too weak.
Avoid using oily, caramelised or avoured coffee. Check that the coffee bean
container has coffee in it and that is it dispensing correctly.
Decrease the drink volume, increase the drink strength.
Turn the coffee neness knob to the left to make the grounds ner.
Make the drink in two cycles by using the 2 cups function.
The appliance is not producing
coffee.
A problem has been detected during preparation of the drink.
The appliance has restarted automatically and is ready for a new cycle.
Why can I not start the descaling or
cleaning program ? Why does my
machine not request to be descaled
or cleaned ?
The machine only requests to be cleaned once it has made several types of coffee.
The machine only requests a descaling cycle once it has made a certain number
of drinks using steam.
A power failure occurs during a
cycle.
The appliance is automatically restarted when power is switched back on.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups EA 8025 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups EA 8025 in the language / languages: English as an attachment in your email.

The manual is 2,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Krups EA 8025

Krups EA 8025 User Manual - English - 12 pages

Krups EA 8025 User Manual - German - 330 pages

Krups EA 8025 User Manual - German, Dutch - 12 pages

Krups EA 8025 User Manual - Dutch - 16 pages

Krups EA 8025 User Manual - French - 12 pages

Krups EA 8025 Quick start guide - All languages - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info