362235
8
Zoom out
Zoom in
Previous page
1/16
Next page
14
The appliance will automatically sequence 2 complete coffee-making cycles.
PREPARING STEAM
Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats up liquids. As you need a
higher temperature to produce steam than to make an espresso, the appliance runs an additional pre-heating phase for
steam.
Press the
key
- Fig. 18.
The
light will flash while the appliance heats up.
Once pre-heating has been completed, the light will remain on continuously and you can start producing steam by
again pressing the
key.
Press the
button again to stop the cycle.
BE CAREFUL, BECAUSE THE CYCLE DOES NOT STOP IMMEDIATELY.
Frothing milk
Pour the milk into your milk jug. Immerse the nozzle in the milk
- Fig. 19
.
Initiate the steam function as explained in the paragraph above.
Once your milk is frothy enough
- Fig. 20 -
again press the key to stop the cycle.
To remove any remaining milk from the steam nozzle, place a receptacle under the nozzle and press the
.key. Let the
steam escape for at least 10 seconds and then again press the
key to stop the process.
The steam nozzle can be removed for more intense cleaning. Wash it out with water and a little washing up liquid and a
small non-abrasive brush. Rinse and dry it
- Fig. 21
. Before putting it back, ensure that the air inlet holes are not blocked
by any milk residues. If necessary, unblock them using the needle supplied
- Fig. 22
. Do not wash the steam nozzle in
the dishwasher.
MAINTAINING YOUR APPLIANCE
Emptying the coffee grounds collector, the coffee tray and the drip tray
If the light comes on, remove, empty and clean the drip tray.
Remove, empty and clean the coffee grounds collector.
Remove the coffee cleaning tray.
The drip tray is equipped with oats to tell you when to empty it.
As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overow.
Rinsing out the circuits: see page 13
Machine cleaning program – total duration: about 13 minutes
When a cleaning operation is necessary, the appliance warns you of this by ashing the ‘
CLEAN
’ light.
This program is only accessible when the machine requests it (i.e. approximately every 300 coffees or espressos).
We recommend that you use pasteurised or UHT milk that has been recently opened. Untreated milk does not give
the best results. After the steam function has been used, the nozzle can be hot, and we recommend that you wait for
a few moments before handling it.
To interrupt the steam function, just press any key. Be careful as the nozzle may be hot. If the nozzle is blocked,
unblock it using the needle supplied. The maximum duration for production of steam per cycle is limited to 2 minutes.
If you rst press the ‘ key and then the ‘ ’ (or vice versa), the second action will not be taken into account.
The
light will remain on if the coffee grounds collector is not slotted in fully or not fitted correctly or if
it has been put back in less than 6 seconds.
You cannot make espresso or coffee while the light is on or is ashing. The coffee grounds collector has a capacity
of 9 coffees.Le collecteur de marc de café a une capacité de 9 cafés.
8


Need help? Post your question in this forum.

Forumrules
1

Forum

krups-ea-8000

Reset search

  • EA8000 stuck on automatic maintenance and then gives error code 13. Any ideas what to try? Submitted on 17-7-2021 at 01:58

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups ea 8000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups ea 8000 in the language / languages: English as an attachment in your email.

The manual is 2,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Krups ea 8000

Krups ea 8000 User Manual - English - 12 pages

Krups ea 8000 Quick start guide - English - 26 pages

Krups ea 8000 User Manual - German - 12 pages

Krups ea 8000 Quick start guide - German - 26 pages

Krups ea 8000 User Manual - Dutch - 12 pages

Krups ea 8000 Additional guide - Dutch - 4 pages

Krups ea 8000 Quick start guide - Dutch - 26 pages

Krups ea 8000 User Manual - Dutch - 18 pages

Krups ea 8000 Quick start guide - Danish - 26 pages

Krups ea 8000 User Manual - French - 12 pages

Krups ea 8000 Quick start guide - French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info