Manual Kruger SECOMAT 130 AH (page 10 of 11) (English, German, French, Italian)

495033

Zoom out

Zoom in

1/11

Water drainage

• Screw the water tank guide rails to

the underside of the machine

• Slide the water tank into these rails

If the water is collected in a tank, it must

be regularly checked and emptied. De-

pending on the temperature and mois-

ture content of the air, the tank may

need to be emptied 1 – 2 times a day.

If the tank is not emptied, this can lead

to water damage.

Wherever possible, the water should

drain automatically.

• Remove water tank (keep for possible

use at a later date)

• Attach connector piece (optional ex-

tra) to the screw thread beneath the

machine

• Put the hose (optional extra) over the

connector piece

• Put the other end of the hose into the

waste pipe (preferably siphoned)

Hanging up the washing

• Leave a minimum gap of 30 cm be-

tween the clothes and the machine

• Hang heavy cotton items (e.g. towel-

ing, jeans, pullovers etc.) in the air

flow near the machine

• Hang large items over two lines or

attach to two lines

• Ensure that the air circulation in the

room is adequate

• Do not obstruct the intake



and

outlet



openings

The most cost-effective way of drying

clothes is not to switch on the clothes

drier until:

a) you have hung up all the wash-

ing.

b) the drying room is full.

If other items are added during the

drying process, the drying time is in-

creased.

Starting the machine

• SECOMAT 130 AH

• Close doors and windows

• Check machine is plugged into the

mains – green power indicator light



should be on

• Set hygrostat controller



to 45%

relative humidity (washing should be

dry at this setting). If the washing is

not dry enough or is too dry, you can

change the setting as follows:

Washing is not dry enough

Set hygrostat to 35 – 40%

Washing is too dry

Set hygrostat to 50 – 55%

• Select appropriate setting on the On/

Off switch



0 = machine off

1 = machine on

The clothes drier works automatically,

i.e. as long as the humidity in the room

remains above the preset value, it con-

tinues to operate. As soon as the desired

level of humidity is reached, the dehu-

midifying function of the clothes drier

stops. If the humidity level in the room

rises again, it automatically begins to

work again. To switch the machine off

completely, the On/Off switch must be

set to ‘O’.

• SECOMAT 130 E

(with end stop)

• To switch on: Press the ‘blue’ button

The clothes drier works automatically,

i.e. as long as the humidity in the room

remains above the preset value, it con-

tinues to operate. As soon as the set level

of humidity is reached, the clothes drier

switches off completely, i.e. it does not

come on again if the humidity level in the

room rises again. The drying process can

be interrupted at any time by pressing

the ‘red’ button.

Cleaning

The refrigeration unit is hermetically

sealed and the fan bearings are provid-

ed with lifetime lubrication. These parts

are therefore maintenance-free.

• Wipe the housing with a damp

cloth.

• Move the air filter



slightly to the

right or left into the machine so that

it can be removed on the opposite

side.

• Remove dust from air filter using a

brush and replace

If it becomes particularly dirty, the inside

of the machine will need to be cleaned.

This must be performed by a refrigera-

tion specialist.

TROUBLESHOOTING

Please check the following points be-

fore taking the machine to a specialist

dealer.

A. Machine does not start

• Is the mains plug correctly inserted?

• Is the fuse in your fusebox OK?

• Is the mains cable or extension cable

(if used) OK?

• Is the hygrostat controller correctly

set (to approx. 45% relative humid-

ity)?

B. Machine is running constantly

• Is the hygrostat controller set to ap-

prox. 45% relative humidity?

• Are the doors and windows closed?

C. The machine is not dehumidifying

the room properly

• Is the air circulation in the room ad-

equate?

• Are the intake and outlet openings

free of obstructions?

• Is the room temperature too high or

too low (see section on Installation)?

• Is the filter clean?

• Only for the AH model: Remove the

small cover  and press with a pencil

or similar against the plug that is now

visible. This resets the overheating

protection device.

If you have checked the above points

and still not managed to rectify the

fault, the machine must be taken to a

refrigeration specialist for inspection.

DISPOSAL

Because the clothes drier contains a

refrigerant, it requires special disposal.

Please contact your specialist dealer or

local waste disposal authority.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Kruger SECOMAT 130 AH in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 0,24 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Kruger SECOMAT 130 AH Manual

Product: