819062

Kress KG745 Manual

16
Zoom out
Zoom in
Previous page
1/156
Next page
16
EN
TROUBLESHOOTING
The following table gives problems and actions that you can perform if your machine does not operate
correctly.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
Problem Solution
1. Mower doesn’t run when
switch lever is activated. A. Check to make sure the button on switch housing is being completely
pushed.
B. Release Switch Lever to turn mower off. Turn mower over and check
that blade is free to turn. If not free, return to an authorized servicer. Blade
should turn freely.
C. Has battery been fully charged? Plug in charger and wait for green light
to come on.
2. Motor stops while mowing. A. Release Switch Lever to turn mower off. Turn mower over and check
that blade is free to turn. If not free, return to an authorized servicer. Blade
should turn freely.
B. Raise cutting height of wheels to highest position and start mower.
C. Has battery been fully charged? Plug in charger and wait for green light
to come on.
D. Avoid overloading the mower. Slow down the cutting pace by pushing
mower slower or raise the cut height. Or both.
3. Mower runs but cutting
performance is unsatisfactory,
or does not cut entire lawn.
A. Has battery been fully charged? Plug in charger and wait for green light
to come on.
B. Release Switch Lever to turn mower off. Turn mower over and check:
Blade for sharpness - Keep blade sharp. Deck and discharge chute for
clogging.
C. Wheel height adjustment may be set too low for grass condition. Raise
cutting height.
4. Mower is too hard to push. A. Raise cutting height to reduce deck drag on grass. Check each wheel for
free rotation.
5. Mower is abnormally noisy
and vibrates. A. Release Switch Lever to turn mower off. Turn mower on side and check
blade to ensure it has not been bent or damaged. If blade is damaged,
replace with a replacement blade. If the underside of the deck is damaged
return mower to an Authorized service center.
B. If there is no visible damage to the blade and the mower still vibrates:
Release Switch Lever to turn mower off, and remove the blade. Rotate
blade 180 degrees and retighten. If mower still vibrates, return the mower to
an authorized service center.
6. Battery charger LED’s not
on. A. Check plug connection.
B. Replace charger.
7. Battery charger LED does
not ip to green. A. Battery needs to be diagnosed. Take to authorized service center.
8. Mower not picking up
clippings with the Grass
Collection Bag.
A. Remove mulch plate when bagging.
B. Chute clogged. Release Switch Lever to turn mower off. Clear chute of
grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten length of
the cut.
D. Bag full. Empty bag more often.
9. When mulching there are
clippings visible. A. Too much cut grass. Raise cutting height of wheels to shorten length of
the cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
10. Low or diminished run-
time after many uses. A. Return to Authorized Service location - may need new battery.
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kress KG745 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kress KG745 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 60.26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info