819116

Kress KC720.X Manual

16
Zoom out
Zoom in
Previous page
1/332
Next page
16
EN
TROUBLESHOOTING
The following table gives problems and actions that you can perform if your machine does not operate
correctly.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
PROBLEM SOLUTION
1. Mower doesn’t run when operating
bail is activated. A. Check to make sure that cutting blade start button is being
completely pressed.
B. Release operating bail to turn mower off. Remove the
battery, turn mower over and check that blade is free to turn.
If not free, return to an authorized servicer. Blade should turn
freely.
C. Has battery been fully charged? Plug in charger and wait for
green light to come on.
D. For starting, press both the cutting blade start button and
pull the operating bail at the same time.
2. Motor stops while mowing. A. Release operating bail to turn mower off. Remove the battery,
turn mower over to check if mower is plugged with grass debris,
remove debris from blade rotation area. Then, check that blade
is free to turn. If not free, return to an authorized servicer. Blade
should turn freely.
B. Raise cutting height of wheels to highest position and start
mower.
C. Has battery been fully charged? Plug in charger and wait for
green light to come on.
D. Avoid overloading the mower. Slow down the cutting pace by
pushing mower slower or raise the cut height. Or both.
3. Mower runs but cutting performance
is unsatisfactory, or does not cut entire
lawn.
A. Has battery been fully charged? Plug in charger and wait for green
light to come on.
B. Release operating bail to turn mower off. Remove the battery. Turn
mower over and check: Blade for sharpness - Keep blade sharp.
Deck and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass condition.
Raise cutting height.
4. Mower is too hard to push. A. Raise cutting height to reduce deck drag on grass. Check
each wheel for free rotation.
5. Mower is abnormally noisy and
vibrates. A. Release operating bail to turn mower off. Remove the
battery. Turn mower on side and check blade to ensure it has
not been bent or damaged. If blade is damaged, replace with
a replacement blade. If the underside of the deck is damaged
return mower to an authorized service center.
B. If there is no visible damage to the blade and the mower
still vibrates: Release operating bail to turn mower off, remove
the battery, and remove the blade. Rotate blade 180 degrees
and retighten. If mower still vibrates, return the mower to an
authorized service center.
6. Battery charger LED’s not on. A. Check plug connection.
B. Replace charger.
7. Battery charger LED does not ip to
green. A. Battery needs to be diagnosed. Take to authorized service
center.
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kress KC720.X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kress KC720.X in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 103.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info