KRT706310 EN
Copyright © 2019 VARO P a g e | 4 www.varo.com
▪ Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
▪ Maintain power tools. Check for misalignment or sticking of moving parts, breakage of
parts and any other condition that may affect the power tool’s operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
▪ Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to stick and are easier to control.
▪ Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could lead to a hazardous situation.
5.5 Service
▪ Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
6 ADDITIONAL SAFETY INSTRUCTIONS FOR LASERS
▪ Warning! The laser beam potentially causes severe eye damage. Never look or stare
directly into the laser beam.
▪ During use, do not point the laser beam at people, directly or indirectly through reflecting
surfaces.
▪ This laser complies with class 2 according to EN 60825-1:2001. The unit includes no
servicing components. Do not open the housing for any reason. If the unit is damaged,
have the damage repaired by an authorized repair agent.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES
▪ When replacing batteries, always replace the complete set. Do not mix old batteries with
new ones.
▪ Prevent removed batteries from short circuiting.
▪ Do not store batteries where the temperature may rise above 50 °C, e.g. in a car which
has been parked in the sun.
▪ Do not burn batteries.
▪ Never attempt to open batteries.
▪ In case of battery leakage, carefully remove the liquid using a cloth. Avoid skin or eye
contact. Do not swallow. In case of skin or eye contact, rinse abundantly for 10 minutes
with clean water and consult a physician.
8 USE
8.1 Inserting/Replacing the batteries
Alkali-manganese batteries are recommended for the measuring tool. Open the battery lid (5)
and insert the batteries. When inserting, pay attention to the correct polarity according to the
representation on the inside of the battery compartment.
8.2 Initial operation
▪ Protect the measuring tool against moisture and direct sun light.
▪ Do not subject the measuring tool to extreme temperatures or variations in temperature.
As an example, do not leave it in vehicles for longer periods. In case of large variations in
temperature, allow the measuring tool to adjust to the ambient temperature before putting
it into operation. In case of extreme temperatures or variations in temperature, the
accuracy of the measuring tool can be impaired.
