813956

Kratki WK440 Manual

22
Zoom out
Zoom in
Previous page
1/338
Next page
22
EN
chimney does not generate too much draught, but, if so, install a chimney-draught stabiliser; alternati-
vely, special chimney terminations for the draught control. The inspection of the chimney ue must be
contracted to a master chimney sweep, and any conversions are obliged to be made by an authorised
service only, so that all the requirements stipulated by the respective national law in force are met.
APPLICATIONS
The free-standing stoves by kratki.pl are stoves from the group of solid-fuel hearths with a manual fuel
load, connected to a building by means of a conduit which transports ue gases out of the building,
and a lockable hearth door. They are designed to burn hardwood, specically, hornbeam, oak, beech,
acacia, elm, maple, or birch, with a humidity of <20% (lignite and charcoal briquettes are also allowed).
They provide an additional heat source for the rooms they are installed in.
NOTE BEFORE / INSTALLATION!
To prevent the risk of re, the heater must be installed in compliance with the rules and regulations of
good building practice, and with the technical guidelines provided in this Installation and Operation
Manual. The design of the chimney system must be by a qualied specialist. Prior to commissioning, a
recorded technical acceptance must be conducted and the chimney sweep and re-specialist asses-
sments attached.
GENERAL REMARKS
a) Prior to the heater’s installation, the chimney ue must be assessed by an expert and accepted for
its technical specications, as well as the technical functionality of leak tightness and ow capacity.
b) The installation and startup of the heater must be carried out by an installation-specialist company
with satisfactory qualications and experience.
c) The heater must be placed as close to the chimney ue as possible. The room it will be installed in
must have a functional ventilation system and the required amount of air for correct heater operation.
d) Before you start using the heater, remove the stickers from the glass.
e) The heater’s technical specications apply to the fuel dened herein.
f) The chimney ues must be inspected in the due time (min. twice a year).
g) Pursuant to the applicable law, a stove may not be the only source of heat, but a supplementary
one to the existing heating system only. The purpose of such a regulation is the necessity to provide
heating for buildings during a prolonged absence of residents.
The heater’s installation must be performed with adherence to the provisions in force within this
standard scope, construction-law requirements and re-safety standards in force in this regard. The
particular provisions on design safety, re safety and safety of use are laid down in the construction
regulations and codes in force in the respective countries.
FUEL CHOICE
Recommended Fuel
- the manufacturer recommends hardwood billets like beech, hornbeam, oak, alder, birch, ash, etc.,
with billet or split log dimensions 30cm long and circumferences between 30 and 50cm, and lignite
briquettes.
- the humidity of the fuel wood for the appliance should not exceed 20%, which is characteristic of
wood seasoned 2 years after felling and stored under cover.
Not Recommended Fuel
You should avoid burning billets of split logs with a humidity of over 20% as it can prevent the applian-
ce from achieving its declared technical specications, and can reduce the heat output.
Burning softwood billets and high-resin wood in the appliance is not recommended, as they result in
heavy smoking and frequent cleaning of the appliance and chimney ue.
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kratki WK440 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kratki WK440 in the language / languages: English, German, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 7.01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info