813987

Kratki PATIO Manual

34
Zoom out
Zoom in
Previous page
1/206
Next page
34
The PATIO heater uses modern B6R-H9 remote controls set in accordance with the European standard
to 868 MHz radio frequencies. The remote control does not require a new transmission code and is
ready for use. When replacing the remote control, a pairing procedure is required. To pair the new
remote with the heater, rst press and hold the RESET button, located on the receiver housing, until
you hear two characteristic signals, then release the button. This activity should be carried out using a
thin, blunt element. Then, press and hold the remote control button until you hear two short beeps
which mean synchronizing the remote control with the receiver.One long signal indicates that the
system components were paired not correctly. Figure 9.
INFORMATION
To view the current version of the software used by the remote control, simultaneously press the
and . Simultaneous pressing the button and the button will display the remote control model.
Deactivating the remote control.
Install batteries. All available icons will appear on the display and will ash. During the ashing, press
the appropriate icon for the function and hold it for 10 seconds. The icon appropriate for the selected
button will ash until the end of the deactivation process. The remote control display shows the icon
adequate for the selected function and two horizontal lines. If the function is deactivated two hori-
zontal lines will appear on the display when pressing the button responsible for its selection. After
replacing batteries, the settings will remain unchanged.
Activating the remote control.
Install batteries. All available icons will appear on the display and will ash. Press the appropriate icon
for the function and hold it for 10 seconds. The icon appropriate for the selected button will ash
until the end of the activation process. The remote control display shows the icon adequate for the
selected function.
NOTE!!!
If, when you try to light it, the control ame goes out, wait for at least ve minutes before trying
again to light the replace.
NOTE!!!
If, after four attempts to light the replace, the control ame will not ignite, close the gas shut-
-o valve to the appliance and contact your service representative.
CAUTION!!!
The remote control should always be kept out of the reach of children and other persons who are
unaware of the consequences of their actions.
CAUTION!!!
Never use tools to change the position of the knobs. Changes to the position of the knobs can
only be made manually; otherwise the controller may be damaged. Contact a service technician
if the knobs are locked.
… 34 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kratki PATIO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kratki PATIO in the language / languages: English, German, French, Italian, Polish, Spanish, Finnish as an attachment in your email.

The manual is 4.06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info