813988
42
Zoom out
Zoom in
Previous page
1/206
Next page
42
REPLACEMENT OF BATTERIES
Batteries in the receiver, remote control or the power supply module can overheat, spill or even cause
an explosion. Do not use batteries that have been exposed to the sun, moisture, heat or vibration.
Install only batteries of the same type and the same manufacturer. Do not install new batteries with
worn ones. The remote control is powered by two AAA batteries. The B6R-R8U receiver and the
G60-ZB90 power module are powered by four AA batteries 1.5V. The battery life in the case of the
remote control and the receiver is estimated at about 1 heating season. The device manufacturer re-
commends the use of alkaline batteries because of the lower risk associated with unsealing. It is also
permissible to use rechargeable batteries. When removing batteries, do not use tools that can cause
a short-circuit. Replacing batteries with conductive objects can permanently damage the electronic
components of the remote control and the receiver.
Replacement of the batteries in the remote control:
Remove the cover located on the rear of the remote control.
Gently remove the used batteries from the remote control.
Install new AAA batteries observing the polarity markings (+/-).
Replace the cover on the back wall of the remote
Replacing batteries in the receiver/power supply module:
Open the cabinet door panel.
Carefully remove the B6R-R8U receiver/G60-ZB90 power module.
Remove the cover.
Remove the used four AA batteries and install new, paying attention to the
polarity markings (+/-) on the receiver/power module.
Replace the cover on the cover receiver/supply module.
NOTE!!!
Replacing batteries in the receiver/power supply module can only be done on a cool replace
with the gas supply cut o.
NOTE!!!
Batteries are classied as hazardous chemical waste, so, after using them, they should not be
disposed of with other household waste.
MANUAL CONTROL
The user selecting the manual control option receives a device equipped with a GV32 controller. Ple-
ase read this manual before operating the control module. Proceeding contrary to the instructions
may result in damage to the gas control system or to the device itself, and may result in re, property
damage or health impairment.
USER MANUAL FOR THE MANUAL CONTROL MODULE
Firing the device should be carried out according to the instructions below. The GV32 gas control sys-
tem has been designed to completely eliminate the need for maintenance or any adjustments. The
knobs are non-removable. Removing the knobs will damage the device. Never attempt to open or
otherwise tamper with the valve or any of its components.
Starting the device:
1. Turn ON / OFF Knob A slightly counter clockwise towards the IGNITION position until it stops. Then
press and hold the knob for 5 seconds (the gas ows to the control burner only).
2. Continue to hold down the knob and at the same time turn it towards the PILOT position (this activa-
tes the piezo pilot of the control burner). Hold down the knob in this position for another 10 seconds
until the control burner ignites (if the pilot does not light up, repeat the procedure immediately
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kratki PATIO MINI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kratki PATIO MINI in the language / languages: English, German, French, Italian, Polish, Spanish, Finnish as an attachment in your email.

The manual is 4.06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info