Manual Kratki One (page 7 of 80) (English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish, Finnish)

813917

Zoom out

Zoom in

1/80

Keep the Bio Fireplace at least 1 m away from all combustible materials and products. Before

installing the Bio Fireplace, make sure that the room it is to be used in has a sufcient natural

ventilation system and no air supply grate is closed or otherwise obstructed. Do not use the

Bio Fireplace in rooms with an internal volume below 40 m3. More than one Bio Fireplace can

be used in a single room if their total fuel consumption does not exceed 0.6 l/h and sufcient

additional ventilation is ensured. The ventilation should change the full air volume in the room

at least once an hour.

he Bio Fireplaces for permanent built-in installation shall be attached on a at or corner wall, or

for drop-in installation in a wall recess made in a non-combustible material or made of building

boards (e.g. re-rated drywall panels). Depending on the Bio Fireplace model, its back panel

may feature holes required for suspended installation or round holes for direct bolting to the in-

stallation substrate. The dedicated installation bolts and wall plugs are supplied with the product

as required by its model. If the Bio Fireplace has not been securely fastened in place, adjust

the bolt tightening torque properly. The Oscar Bio Fireplace must be fastened with the included

installation rail. If the Bio Fireplace is dropped into a wall recess, maintain the required gap be-

tween the Bio Fireplace and its casing within the wall recess (10 mm minimum).

Standalone Bio Fireplaces do not require permanent fastening to any structural component.

Some standalone product versions may require assembly before use (Fig. 4 to 6). Tabletop Bio

Fireplaces are standalone products which can be placed directly on furniture or wall shelves.

Depending on the Bio Fireplace model, it may have a glazing system included with a special

base for the glass pane assembly, as shown in Fig. 7.

REFUELLING AND FIRING

Light the re in the Bio Fireplace once its installation has been completed. Do not refuel with

the bio fuel when the Bio Fireplace is burning. Do not light the re in the product when hot. The

bio-fuel canister will remain hot for up to 1 hour after the re has died out. Inspect the bio-fuel

canister for integrity and leaks every time before refuelling. The bio-fuel canister features a safe-

ty absorbing insert to prevent spilling the bio fuel if the Bio Fireplace is tilted or falls to a side.Do

not overll beyond the maximum capacity shown by the MAX mark on the bio-fuel canister (Fig.

1). Do not light the Bio Fireplace if overlled with the fuel. If the bio fuel is spilled, immediately

wipe it off all surfaces with paper towel. Light the Bio Fireplace with long replace matches or

a replace lighter. The ames have the right colour and height after 15 minutes from lighting.

The ame height depends on the ventilation of the room. The bio-fuel canisters with a sliding

damper (Fig. 2 a) allow adjusting the ame height by moving the handle to set the sliding damper

opening ratio. Adjust the ame height so that the top section of the Bio Fireplace body is not

exposed directly to re. Keep a safe distance of 0.5 m minimum from the Bio Fireplace when lit

and burning. Depending on the model, the fuel

consumption may vary from 0.2 l/h to 0.6 l/h.

EXTINGUISHING

To extinguish the ame in the Bio Fireplace, operate the handle to close the sliding damper and

isolate the air ow from the burner (Fig. 2 b). Before re-lighting the Bio Fireplace, wait for it to

cool down to ambient temperature. Never put out the Bio Fireplace with water or any liquid. If

the spilled bio fuel is ignited, use a dry powder re extinguisher or smother the re with a non-

ammable material. The Bio Fireplaces without a sliding damper are put out by isolating the air

from the burner with a dedicated snuffer included with the product (Fig. 3).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Kratki One in the language / languages: English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0.68 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Kratki One Manual

Product: