508531
24
Zoom out
Zoom in
Previous page
1/60
Next page
Description of function - Troubleshooting
The thermostat (4) is controlled via a thermo-sensor (18) mounted at the outlet of
the heaiting coil.
In the switchbox (below the operating panel), a fuse (F1) is installed on the board
protecting the motor (11) of the fuel pump and the ventilator. If the motor is overloaded
the fuse trips. This may happen if the fuse pump is blocked or sluggish - the same
applies if the ventilator is blocked or sluggish or in case of an electrical malfunction.
Another fuse (F2) on the board trips, if the ignition transformer (17) is faulty.
There is a thermosensor (21) in the waste gas tube, which controls an excess
temperature relay with trigger function (19), i.e. when the exhaust gas temperature
in the chimney increases above 230 °C, this relay triggers. To activate it again,
you must wait until the combustion unit has cooled down, i.e. approximately 15
minutes. Then, you can press the button under the cover (19) again. The excess
temperature relay can trigger when the machine is operated over a longer period
in the highest steam level, or when there is lots of soot on the heating coil due to
poor combustion, or when the inside of the heating coil is calcied, so that there is
no ventilation (cooling).
As further safety function, the burner is also switched off, when the water tempe-
rature exceeds 147 °C.
The appliance is equipped with a visual ame monitoring device. A photo cell (16)
is installed above the burning chamber, switching off the fuel supply if the ame is
extinguished.
To avoid an overheating of the burning chamber a ow indicator (10) is installed in the
high pressure system between the high pressure pump (6) and the burning chamber
enabling a fuel supply only if water streams through the heating coil at the same time.
24
Control board (p. 28-29)
The control board is equipped with two LEDs for trouble shooting.
L1: - illuminated, if the burner has been released but the ame is not burning. If
the ame starts burning within 2 seconds, the LED goes out.
If the LED does not go out the combustion has to be checked. If the LED is
not illuminated at all, the ame sensor has to be checked.
Nevertheless the cleaner can be used as a cold water high pressure cleaner
even if the burner is switched off.
L2: - permanently illuminated, if the overcurrent release has tripped.
- blinking, if the fuel ow valve detects only a low quantity of fuel in the tank or
if it is defctive.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kranzle Therm C 13-180 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kranzle Therm C 13-180 in the language / languages: English as an attachment in your email.

The manual is 2,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kranzle Therm C 13-180

Kranzle Therm C 13-180 Additional guide - English, German - 32 pages

Kranzle Therm C 13-180 User Manual - German - 60 pages

Kranzle Therm C 13-180 User Manual - Dutch - 60 pages

Kranzle Therm C 13-180 User Manual - French - 31 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info