716903
13
Zoom out
Zoom in
Previous page
1/29
Next page
24 25
Insufficient quantity of electricity
If there are too many collectors in your
proximity connected to the network at the
same time, the available voltage and the
current intensity may decline. Consequently
the motor of the high-pressure cleaner does
not start or even blows. The power supply
may also be insufficient if the power supply
cable is too long or too thin. If extension
cables are too long, this may lead to a
voltage drop causing malfunctions or
start-up difficulties.
Check the line fusing and have the voltage and the available current
intensity checked by an expert in case of uncertainty (see technical data).
Electrical connection
The voltage indicated on the rating plate must match the voltage from the power
source. The high-pressure cleaner is supplied with a power supply cable.
The mains
plug must be fitted to a standard grounded socket with a 30 mA residual current
operated device. Connection up to the mains must be carried out by a properly
trained electrician and must comply with the requirements of IEC60364-1.
The socket is to be protected on the mains side according to the specifications (see
technical data in the spare parts list). When using an extension cable, this must have
an earthed lead which is properly connected to the socket. The conductors of the
extension cable must have the following minimum cross-section:
at 18 kW: 6 mm
2
at 24 kW: 10 mm
2
at 36 kW: 16 mm
2
at 48 kW: 25 mm
2
If extension cables are too long, this may lead to a voltage drop
causing malfunctions. When using a cable drum, always keep the
cable wound as far as possible.
Was Sie unbedingt beachten müssen: Problem Wassermangel
Lack of water occurs more often than you
probably believe. The more powerful a high-
pressure cleaner is the greater is the danger
that a lack of water occurs. If there is only
an insufficient amount of water available,
cavitation (water-gas mixture) arises inside
the high-pressure pump, which is normally
noticed too late or even not at all. The high-
pressure pump will be destroyed. Please
check the available quantity of water by fil-
ling a bucket with liter scale for one minute.
Functional details Functional details
Required minimum quantity of water (see technical data).
If the metered quantity of water is too small, you have to use a
different water connection, guaranteeing the necessary output.
Lack of water leads to an accelerated wear of the joints (no warranty).
Never let the high-pressure pump run dry for more than 60 seconds.
Water supply
Please pay attention to the regulations of your waterworks compa-
ny! In accordance with DIN EN 61770, the high-pressure cleaner may
not be directly connected to the public drinking water supply lines.
A brief connection however is permissible according to DVGW
(German Association for Gas and Water Affairs) if a non-return
valve with tube ventilator (Kränzle item no.: 410164) is built into the
water supply. Once the water has passed through the non-return
valve it is no longer considered as drinking water. Also indirect
connection to the public drinking water supply lines is permissible
by way of free emission in accordance with EN 61 770; e.g. by using
a reservoir with a float valve. Direct connection to a non-drinking
water supply line is permissible.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kranzle e-therm 603 M 36 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kranzle e-therm 603 M 36 in the language / languages: English as an attachment in your email.

The manual is 6,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kranzle e-therm 603 M 36

Kranzle e-therm 603 M 36 Additional guide - English, German - 25 pages

Kranzle e-therm 603 M 36 User Manual - German - 29 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info