508569
12
Zoom out
Zoom in
Previous page
1/29
Next page
22 23
Putting into operation - Assembly
For reasons of packaging, handlebar
and side boom arm, to include broom
and Vee belt are not assembled. After
unpacking the Kränzle 1+1, first
assemble the handlebar and the side
broom next.
1. Bolt handlebar to both sides of the
housing, use the wing bolts .
Note: The handlebar can be mounted
in two positions, as suitable for the
operator´s tallness.
For short people: Install the handlebar
with handle rod bent to downside.
For average and bigger tallness: Install
the handlebar with handle rod bent to
the top end.
2. Unpack side broom arm and broom.
Plug side broom on broom shaft and
secure with bolt; use 10 mm spanner
size. Do not overtorque bolt to avoid
damage to the broom hub. Place the
Vee belt in the pulley overthe RH wheel.
side broom will have to rotate CCW
when machine moves forward
(top view).
Inbetriebnahme
4
Zusammenbau
Holmanbau
Aus Verpackungsgründen sind der
Holm sowie der Seitenbesenarm
einschließlich Seitenbesen und
Keilriemen nicht montiert. Nach dem
Auspacken der KRÄNZLE 1+1
einschließlich der Holm-Befestigungs-
teile ist zunächst der Holm, dann der
Seitenbesenarm anzubauen.
Holm mit den Flügelschrauben
(A/1) links und rechts am Gehäuse
anschrauben.
Hinweis: Der Holm läßt sich in zwei
Stellungen, abgestimmt auf die
Körpergröße des Bedienungsperso-
nals, montieren.
Für kleine Körpergrößen: Holm mit
Griffstange nach unten abgebogen
montieren.
Für mittlere und große Körper-
größen: Holm mit Griffstange nach
oben abgebogen montieren.
A
1
Inbetriebnahme
4
Zusammenbau
Holmanbau
Aus Verpackungsgründen sind der
Holm sowie der Seitenbesenarm
einschließlich Seitenbesen und
Keilriemen nicht montiert. Nach dem
Auspacken der KRÄNZLE 1+1
einschließlich der Holm-Befestigungs-
teile ist zunächst der Holm, dann der
Seitenbesenarm anzubauen.
Holm mit den Flügelschrauben
(A/1) links und rechts am Gehäuse
anschrauben.
Hinweis: Der Holm läßt sich in zwei
Stellungen, abgestimmt auf die
Körpergröße des Bedienungsperso-
nals, montieren.
Für kleine Körpergrößen: Holm mit
Griffstange nach unten abgebogen
montieren.
Für mittlere und große Körper-
größen: Holm mit Griffstange nach
oben abgebogen montieren.
A
1
5
Seitenbesenanbau
Seitenbesenarm und Seitenbesen
aus der Verpackung entnehmen.
Seitenbesen auf die Besenwelle auf-
stecken und mit Halteschraube be-
festigen. Schlüsselweite: 10 mm.
(Halteschraube nur leicht anziehen,
so daß die Besennabe nicht ge-
quetscht wird.
Keilriemen über das rechte Rad in
die Nut der Riemenscheibe so
einlegen, daß der Seitenbesen bei
Vorwärtsfahrt gegen den Uhrzeiger-
sinn dreht (von oben gesehen).
Seitenbesenarm mit Bolzen (C/1)
und Halteklammer (D/3) befestigen
(Bolzen von außen nach innen ein-
stecken)
Seitenbesen herunterschwenken
und nach Lösen der Rändelmutter
(D/2) mit Handrad (D/1) die richtige
Besenauflage einstellen. Der
Seitenbesen darf nur mit ca. 2/3
seines vorderen Umfanges den
Boden berühren. Rändelmutter
(Kontermutter) wieder anziehen.
Keilriemenspannung kontrollieren,
ggf. spannen (siehe Absatz “Seiten-
besen” auf Seite 10)
Inbetriebnahme
B
C
D
1
3
1
2
General rules
1
1
Intended Use
The Kränzle 1+1 hand pushed sweeper is exclusively intended for ordinary
sweeping of surfaces such as production areas, warehouses, parking spaces and
pedestrian crosswalks for sweeping up dry and moist refuse.
Any other use above and beyond is considered as improper use; the manufacturer
shall not be responsible for any damages resulting from any such improper use.
Intended use shall also include compliance with manufacturer
specified maintenance intervals.
The hand pushed sweeper is intended for use on flat surfaces.
With the side broom pressed down, you can easily push the machine across the
area to be cleaned. This should be done at normal sliding speed (approx. 3 km/h).
The sweeping performance depends on the rev speed of the sweeping machine
and consequently on the speed at which the machine is pushed over the surface.
Depending on the type of surface, the required push force ranges between 3 – 3.5 kg.
If the machine is to be moved over longer distances without sweeping, make
sure to pull it backwards. The sweeping functions will be disabled due the
integrated freewheel.
The machine must not be used to remove hazardous dusts.
Acceptance of Machine
Make sure to check the machine after its arrival for any potential transportation
damage. This will be compensated on condition that you have the damage
certified by the forwarding agent.
EN
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kranzle 1plus1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kranzle 1plus1 in the language / languages: English, German, French as an attachment in your email.

The manual is 2,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kranzle 1plus1

Kranzle 1plus1 User Manual - German - 32 pages

Kranzle 1plus1 User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info