668710
23
Zoom out
Zoom in
Previous page
1/120
Next page
23
Warning
The stand must be installed by at least two people.
Installation precautions
Be sure to observe the following precautions in order to
safely and correctly perform the installation.
Make sure that the correct parts are in the correct ori-
entation and position, and perform the installation in
the order of the steps provided.
Other precautions
Observe the following precautions aer the stand has been
installed.
• Loosenedscrews
Since the screws may become loose as time passes af-
ter installation, we recommend periodically checking
for loose screws. In addition, if you feel that the stand
shakes excessively, it may be due to screws becoming
loose. In that case, re-tighten them.
• Whentransportingtheinstrument
Transporting the instrument with the stand installed
may result in unforeseen damage. Remove the stand
from the SP-280, and then transport them separately.
Aer they have been transported, re-install the stand
as described in “Installing the stand”.
• Removal
Remove the stand by reversing the installation proce-
dure. After removal, store the screws and other parts
so they will not be lost.
Installation procedure
Make sure that all of the following parts are available.
In addition, check if enough of the bolts on the front legs
extend out (14 mm or more), and then install the legs aer
adjusting the bolt lengths.
If the bolts are not long enough (less than 14 mm), turn
the adjusters until they reach an appropriate length.
Front leg × 2
Rear leg × 2
Knob bolt A × 2
14 mm or more
OK
NG
Less than 14 mm
Knob bolt B
Knob bolt B
Brace
Brace
Adjusters
Installing the stand
In order to prevent damage to the keyboard or knobs of
the SP-280, prepare some magazines, fabric or moderately
sti cushions (see below).
1. TurnovertheSP-280.
In order to avoid placing the SP-280 directly on the
oor, place magazines or fabric at each end as shown
below, and then place the instrument upside-down on
top of them.
When turning over the SP-280, be careful that it does
not become unbalanced and dropped.
When magazines are used
2. Installthefrontlegs(oneeachontheleandright).
Screw the front legs (without braces attached) clock-
wise (direction of arrow) into the screw holes on the
keyboard side of the stand base.
Make sure that the adjusters are not loose.
3. Installtherearlegs(oneeachontheleandright).
Screw the rear legs (with braces attached) clockwise
(direction of arrow) into the screw holes on the back
side of the stand base.
Keyboard side
Rear leg
Front leg
Stand base
Adjusters
4. LoosenknobboltsBforthebracesattachedtothe
rearlegs.
5. Aeradjustingthebracessothatthescrewholeon
theirendscontacttheinstallationpositionsonthe
SP-280,securethebraceendswithknobboltsA.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Korg SP-280 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Korg SP-280 in the language / languages: English, German, French as an attachment in your email.

The manual is 6,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info