488479
7
Zoom out
Zoom in
Previous page
1/58
Next page
Installation
Korg 1212 I/O 3
English
Hold the 1212 I/O by its edges
Did we already mention that the 1212 I/O uses a whole bunch of delicate
electronic components? Well, OK, so we’ve said it again. To avoid
damaging those lovely little silicon jewels,
always hold the 1212 I/O by the
edges of the card,
or by the metal jack panel (where the connectors are).
Don’t touch the electronic parts, the PCI connector pins, or any of the traces
on the board (those little silvery paths that run between the components).
There, we’re done nagging now.
Analog levels: +4 or -10
The 1212 I/O’s analog inputs and outputs can be configured for use with
either +4 dBu or -10 dBV signal levels, to allow clean interfacing with a
wide variety of equipment. You can even set the input and output levels
independently, if desired, so that you can record at -10 and play back at +4,
or vice versa.
The 1212 I/O ships from the factory configured for -10 input and output. If
you will be working with -10 levels, then you can jump ahead to the next
section, “Installing the 1212 I/O card in your computer,” on page 5. If you
need to switch either inputs or outputs to operate at +4, read on.
Setting the analog levels
The nominal analog signal levels are set by several
jumpers
on the card’s
circuit board. A jumper is a small black connector which fits over a pair of
metal pins mounted on the board. The jumper makes an electrical
connection between the pins, just as if you were to solder a wire between
them. Unlike a wire, however, jumpers can be easily installed and
removed. The diagram below shows what they look like:
Jumpers, installed and removed
There are six jumpers on the 1212 I/O circuit board; each one is labeled
with a small “JP” (for “jumper”) followed by a number. The upper group of
four jumpers, labeled JP1 through JP4, set the input level; the lower group
of two, labeled JP5 and JP6, set the output level. The locations of the
jumpers are shown in the diagram below.
Jumper Removed (+4 dBu) Jumper Installed (-10 dBV)
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Korg SoundLink DRS 1212 I-O at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Korg SoundLink DRS 1212 I-O in the language / languages: English as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Korg SoundLink DRS 1212 I-O

Korg SoundLink DRS 1212 I-O User Manual - German - 67 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info