668718
399
Zoom out
Zoom in
Previous page
1/408
Next page
395
Troubleshooting
Appendix
Troubleshooting
Problem Solution Page
General problems
Power does not turn on Make sure that (1) the power cable is plugged into the outlet, (2) the cable is plugged into the connector on
the back of the instrument, (3) and is not damaged, (4) there are no problems with the mains.
Is the POWER LED turned on?
If the power still does not turn on, contact your dealer or the nearest KORG Service Center.
Power does not turn off Press the POWER button again and keep it pressed for a few seconds. At the end, the buttons LED will turn
off, and the instrument will be set to standby.
No sound Is the MASTER VOLUME knob of the Pa600 set to a position other than “0”?
Is the Spearkers parameter turned off? Turn it on. 234
Check the connections to your amp or mixer.
Make sure that all the components of the amplifying system are turned on.
Is the Local parameter set to off? Turn it on. 232
Is the Attack parameter value too high? Set it to a lower value, to let the sound start faster. Is the Volume
parameter too low? Set it to a higher value.
101, 109
Lowest note are not played When the SPLIT LED is turned on, the keyboard is divided into a Lower part (lower notes, below the split
point) and an Upper part (higher notes, above the split point). Is the Lower track muted? Unmute it.
Wrong sounds Do the USER banks contain modified data? Load the appropriate data for the Song or the Style you wish to
playback.
243
Has one of the USER Drum Kits been modified? Load the appropriate Drum Kits. 243
Have the Styles or Performances been modified? Load the appropriate data (Styles or Performances). 243
Sound does not stop Make sure that the Damper pedal calibration is correctly set. 229
The selected Style or Song cannot
start
Make sure that the Clock parameter is set to Internal. If you are using the MIDI Clock of another device, you
must set the MIDI Clock parameter to MIDI or USB (depending on the port the Pa600 is hooked to the other
device through) and make sure that the external device transmits MIDI Clock data.
232
Does not respond to MIDI messages Make sure that all MIDI or USB cables are connected correctly. 270
Make sure that the external device is transmitting through MIDI channels enabled to receive in the Pa600. 233
Make sure that the MIDI IN Filters of the Pa600 do not prevent the reception of messages. 234
Percussive instruments are not played
correctly
Make sure that the Drum track is set to Drum Mode and the external device has not transposition applied. 107, 180
Some “clicks” can be heard when
playing a percussive instrument
This is part of the sound, and not a problem.
A background noise can be heard
after selecting a Performance, Style or
STS
The selected Performance, Style or STS recalled the effect “17 St. Analog Record”, simulating the noise of a
old vinyl recording.
Media related problems
Cannot format a device Is the USB cable correctly connected?
Is the USB device correctly powered?
Is the device inserted correctly?
Is the write protect tab of the disk or card in the protect position? Unprotect it.
Cannot save data to a device Is the device formatted? 252
Is the device inserted correctly?
Is the write protect tab of the disk or card in the protect position? Unprotect it.
Cannot load data from a device Is the device inserted correctly?
Does the device contain data compatible with the Pa600? 240
The message “Over Current Condition
Detected on USB port: please remove
the USB media” appears in the display
The USB device is probably defective, due to a short circuit, and cannot be used. While this will not damage
the Pa600, it is advisable to remove the device.
399


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Korg PA600QT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Korg PA600QT in the language / languages: English as an attachment in your email.

The manual is 39,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info