500238
195
Zoom out
Zoom in
Previous page
1/244
Next page
193
Effects
Pitch/Phase Mod.
When “Control Mode” = LFO, the intensity of resonance var-
ies according to the LFO. The LFO sways between positive
and negative values, causing resonance to occur between
specified pitches an octave apart in turn.
When “Control Mode” = D-mod, the resonance is co
ntrolled
by the dynamic modulation source. If JS X or Ribbon is
assigned as the modulation source, the pitch an octave
higher and lower can be controlled, similar to when LFO is
selected for Control Mode.
a: LFO/D-mod Invert
When “Control Mode” = LF
O or D-mod, the controlled pha
se
of either Voice 1 or 2 will be reversed. When the resonance
pitch is set for Voice 1 (Resonance has a positive value),
Voice 2 will resonate at a pitch an octave below (Resonance
has a negative value).
d: Voice1: Pitch, d: Fine [cent], g: Voice2: Pitch, g: Fine
[cen
t]
The Pitch parame
ter specifies the pitch of resonance by note
name. The “Fine” parameter allo
ws for fine adjustment in
steps of cents.
e: High Damp [%], h: High Damp [%]
This parameter sets the damping amount of resonant sound
in the high range. Lower values wi
ll make a metallic sound
with a higher range of harmonics.
030: Doppler
Thiseffectsimulates the“Doppler effect” ofa moving
soundwithachangingpitch,similartothesirenofan
passing ambulance. Mixing the effect sound with the
drysoundwillcreateauniquechoruseffect.
a: LFO Mode, a: Src, b: LFO Sync
The “LFO Mode” parameter switches LFO operation mode.
When Loop is selected, the Doppler effect
will be created
repeatedly. If “LFO Sync” is set to On, the LFO will be reset
when the modulation source specified with the “Src” parame-
ter is turned on.
When “LFO Mode” is set to 1-Sh
ot, the Doppler effect is cre-
ated onl
y once when the modulation source specified in the
“Src” field is turned on. At this time if you do not set the “Src”
parameter, the Doppler effect will not be created, and no
effect sound will be output.
The effect is off when a value for the modulation source specified for
the “Src” parameter is smaller than 64, and the effect is on when the
value is 64 or higher. The Doppler effect is triggered when the value
changes from 63 or smaller to 64 or higher.
e: Pitch Depth
With the Doppler effect, the pitch is raised when the sound
approaches, and the pitch is lowered when the sound goes
away. This parameter sets this pitch variation.
f: Pan Depth
This parameter sets the width of the stereo image of the effect
soun
d. With larger values, the sound
seems to come and go
from much further away. With positive values, the sound
moves from left to right; with negative values, the sound
moves from right to left.
a
LFO Mode
Switches LFO operation mode
Loop, 1-Shot
,
Src Off...Tempo
When LFO Mode is set to 1-Shot, this modulation source triggers the LFO
b
LFO Sync Off, On
Switches between LFO reset on and off when LFO Mode is set to Loop
c
LFO Frequency [Hz] 0.02...20.00Hz
Sets the LFO speed Fx:009,
Src
Selects the modulation source of LFO speed
Off...Tempo
Amt –20.00...+20.00Hz
Sets the modulation amount of LFO speed
d
BPM/MIDI Sync Off, On
Switches between using the frequency of the LFO speed and using the
te
mpo and notes Fx:009,
BPM
Selects MIDI
Clock and assigns tempo
MIDI, 40...240
Fx:009
Base Note
                 
Selects the type of notes that specify the LFO speed Fx:009
Times x1...x16
Sets the number of notes that specify the LFO speed Fx:009
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Pan Depth
D
-mod
+
Trigger
LFO Mode = 1-Shot
Doppler
LFO
e
Pitch Depth
Sets the pitch variation of the moving sound
0...100
,
Src
Selects the modulation source of pitch variation
Off...Tempo
Amt
Sets the modulation amount of pitch variation
–100...+100
f
Pan Depth
Sets the panning of the moving sound
–100...+100
,
Src
Selects the modulation source of panning
Off...Tempo
Amt
Sets the modulation amount of panning
–100...+100
g
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175
–100...+100
Pitch
Higher
Doppler - Pitch / Pan Depth
Lower
Original Pitch
Left
Center
Right
Pitch Depth
Pan Depth
< < < < < <<<<<< >>>>>> > > > > >
VolumeLouder
Louder
Pan Depth
= (–) value
Pan Depth
= (+) value
195


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Korg microARRANGER at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Korg microARRANGER in the language / languages: English as an attachment in your email.

The manual is 24,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Korg microARRANGER

Korg microARRANGER User Manual - German - 246 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info